This paper refers to magnetic field shielding effectiveness Sh of the selected iron-based amorphous alloys and some magnetic composites. The measurement conditions were chosen regarding the potential sources such as energetic lines or electric devices. As it was shown, the shields made of amorphous and optimized (in amorphous phase) melt spun ribbons can be applied as highly efficient and flexible shields. In the group of the tested alloys, the highest SH reveal (at H = 110 A/m and f = 55 Hz): Fe84 Cr2 B14 (95%) and optimized Fe72 Co10 Nb6 B14 (97%) and Fe80 Nb6 B14 (92%). In the case of the tested composites, a significant decrease of SH was observed. The shielding effectiveness decreases with decreasing size of magnetic addition due to breaking magnetic flux circuit and dipolar interactions between particles. For the composite with magnetic flakes of 4 mm in diameter SH is about 60%; therefore, it can be applied as coatings in order to fulfill human protective standards. For the composites with micro and nano-sized magnetic powder SH does not depend of the composition which suggests that a response to a magnetic field is fully influenced by the demagnetization effect.
In this paper we present self-designed mould suction casting apparatus allowing preparation of bulk samples in a form of rods (1.5 mm in diameter and about 3 cm in length). Making use of the apparatus the following compositions of Fe80Nb6B14, Fe76.2Nb5.7B13.8Gd4.8, Fe69.9Nb5.2B12.2Gd13, Fe76.2Nb5.7B13.8Y4.8, Fe69.9Nb5.2B12.2Y13, Fe61.5Nb4.6B10.8Y23.1 alloys were prepared. Phase and microstructure identification were curried out by making use of X-ray diffraction measurements. The obtained results show that the constructed apparatus fulfill all conditions required for such technique. Gadolinium as an alloying addition causes full amorphization in the case of the Fe76.2Nb5.7B13.8Gd4.8 alloy. In the other cases the structure was found to be nanocrystalline which is discussed in the paper.
1 March 2009 in Journal of Materials Processing Technology