This paper reports on the progress for contacting PERC structures with atmospheric Ag-coated Cu (Ag-c-Cu) screen-printable paste. The preliminary efficiency of >19% on the commercial size silicon wafers is very encouraging, in particular because the cells were sintered at the same peak temperature as the standard Ag paste. The cell efficiency was controlled by the low fill factor of 73.6% due to high series resistance (Rs) of 1.59 Ωcm −2 The high Rs was due to poor printing resulting from non-optimized rheology and viscosity of the Ag-c-Cu. Because this paste was made through the cavitation method instead of the three-roll-milling, the finger widths are very narrow, which would further reduce the metal foot print and cost. This is good news for the concern about Cu diffusion into silicon at high temperature as the Jo 2 for this cell and others remain in the 10 −9 A/cm 2 suggesting the junction is not compromised.
This paper reports on the investigation of cavitated silver paste produced by cavitation technology as a cost-effective alternative to traditional three-roll milling. Cavitation, utilizing high-frequency sound waves, enhances metal paste dispersion, reduces oxidation, extends shelf life, and minimizes waste. Passivated emitter and rear cell solar cells made with cavitated silver paste achieved 21% energy conversion efficiency, slightly lower than the 22% efficiency of a conventional paste. A cavitated paste produced finer gridlines, reducing silver usage and costs but increasing contact resistance, leading to a lower fill factor. Despite this, cavitation technology shows promise for more efficient and cost-effective solar cell production. Further research is needed to optimize efficiency and resistance, highlighting the potential for cavitation technology in commercial applications.