In indoor mobility scenarios, optical camera communication (OCC) performance is compromised by motion, occlusion, frame loss, and illumination variations, limiting its applicability in mobile Internet of Things (IoT) systems. This paper proposes a hybrid on–off keying (OOK)–OFDM architecture that separates a low-rate metadata channel (OOK) from the high-speed payload channel (OFDM). The integration is achieved via amplitude overlay, wherein small, fixed biases are embedded in the OFDM waveform to encode OOK bits without affecting the payload spectrum. The transmitter employs four-QAM modulation across 16 subcarriers to generate a real-valued signal suitable for optical transmission and applies Reed–Solomon RS(15,11) coding for error correction. The receiver incorporates a multiprocessing pipeline for efficient parallel processing, leveraging YOLOv11n for high-speed LED detection and LightOCCTrack for robust multi-LED tracking. This framework enables adaptive region-of-interest (RoI) extraction, block-based symbol correction, temporal redundancy compression for OOK, and sequential buffering for parallel multi-LED decoding. Experiments with up to five LEDs over distances of 4–10 m demonstrate high detection accuracy (mAP@$50=0.995$ ; mAP@50–$95=0.850$ ; inference time $\approx ~2.4$ ms), superior tracking performance (MOTA = 0.9701; MOTP = 0.1538), and real-time operation with frame rates increased from 24.60 to 26.36 fps (+7%). The system achieves data rates of 6.92–7.68 kb/s per LED with a bit error rate of approximately $10^{-4}$ . The experiments were performed indoors with relative speeds up to approximately 7 km/h using a 26 fps rolling-shutter camera. The results therefore demonstrate indoor mobility, and vehicle-to-vehicle (V2V) deployment will be investigated in future work.
Understanding power consumption conditions is necessary for optimizing UAV energy use, particularly during flight under varying weather conditions and environmental factors. Maintaining UAV energy while accounting for multiple influencing variables and vulnerability to weather conditions provides an appropriate case study for advanced predictive modeling. This study investigates UAV power consumption during hovering flight by forecasting power usage using a MDFA network to improve prediction accuracy and better adapt to rapid weather-induced variations. To capture intricate temporal dependencies and recurrent oscillatory behavior, the integrated model combines multi-scale dilated convolutions with a Fourier-enhanced mechanism. According to the experimental results, this model achieves 3% error reductions under all tested flight conditions, indicating a significant improvement in performance. Overall, the MDFA model consistently showed better performance under high power consumption conditions than under low power consumption conditions, and it produced the lowest error in heavy flight compared to low and medium flight.