This paper presents a method based on signal correlation to detect delamination defects of widely used carbon fiber reinforced plastic with high precision and a convenient process. The objective of it consists in distinguishing defect and non-defect signals and presenting the depth and size of defects by image. A necessary reference signal is generated from the non-defect area by using autocorrelation theory firstly. Through the correlation calculation results, the defect signal and non-defect signal are distinguished by using Euclidean distance. In order to get more accurate time-of-flight, cubic spline interpolation is introduced. In practical automatic ultrasonic A-scan signal processing, signal correlation provide a new way to avoid problems such as signal peak tracking and complex gate setting. Finally, the detection results of a carbon fiber laminate with artificial delamination through ultrasonic phased array C-scan acquired from Olympus OmniScan MX2 and this proposed algorithm are compared, which showing that this proposed algorithm performs well in defect shape presentation and location calculation. The experiment shows that the defect size error is less than 4%, the depth error less than 3%. Compared with ultrasonic C-scan method, this proposed method needs less inspector’s prior-knowledge, which can lead to advantages in automatic ultrasonic testing.
Tunnel Boring Machines (TBMs) have been the main equipment for tunneling and underground construction due to their high safety performance and tunneling efficiency. However, the unknown and changing geological conditions during construction pose a challenge to TBM construction. As one of the essential parameters of rock properties, accurate acquisition of uniaxial compressive strength (UCS) is crucial for TBMs to adapt to changing ground conditions in a timely manner. Therefore, this study proposes a Catboost intelligent model based on Bayesian Optimization to predict UCS. Rock mass are velocity information and key TBM operational parameters are used as model input variables. The Gaussian data augmentation method is used to compensate for the difficulty of obtaining field data in large quantities. The Zhujiang Delta Water Resources Allocation Engineering field data are used in the model, and the obtained evaluation indicators MAPE, RMSE, VAF and a20-index are obtained as 9.91%, 499.38 MPa, 90.7% and 0.95, respectively. In addition, another project is selected to verify the applicability of the model. The validation results also confirm that the model is valid and reliable when applied to practical engineering.
A short-circuit fault in the electromagnetic coil of the electromagnetic converter unit, which serves as the active magnetic bearing (AMB), has the potential to irreversibly compromise the stability of the AMB unit. This article proposes a rapid and precise methodology for diagnosing short-circuit faults in electromagnetic coils of AMB systems based on overvoltage. This article elucidates the mechanism of overvoltage generation when driving the electromagnetic coil in a silicon carbide (SiC) half-bridge switching power amplifier. This article presents an analysis of the influence of the driving circuit on the electromagnetic coil overvoltage and the relationship between the overvoltage amplitude and the electromagnetic coil impedance parameters. A theoretical analysis was conducted to ascertain the relationship between the degree of short-circuit fault in the electromagnetic coil and the overvoltage reflection coefficient. Based on this relationship, a Smith circle diagram was constructed. The overvoltage amplitude can be accurately determined by detecting it, thus allowing the degree of short-circuit failure of the electromagnetic coil to be identified. The AMB system was tested, and experiments were conducted on the degree of short-circuit fault and the overvoltage reflection coefficient of the electromagnetic coil. The results demonstrate that the method is highly accurate in fault diagnosis.