In this study, 2205 duplex stainless steel was friction‐stir‐welded at different welding speeds. The microstructural characteristics such as grain sizes, grain boundary misorientation angles, and phase contents in the stir zones of the joints were detected. The potentiodynamic polarization and electrochemical impedance spectroscopy were also measured to evaluate the corrosion property of the stir zones. The effects of the microstructures on the corrosion property for friction‐stir‐welded 2205 duplex stainless steel were analyzed. The results indicated that the FSW process refined the grains and increased the ferrite contents in the stir zones. With increasing the welding speed from 30 mm/min to 50 mm/min, the grain size in the stir zone decreased from 1.64 μm to 0.96 μm, the ferrite content decreased from 59% to 54.4%, and the fractions of low angle grain boundaries for austenite and ferrite phases decreased from 63.9% and 92.6% to 18.0% and 41.1%, respectively. In this study, the effect of grain size on the corrosion resistance was the most significant and it was followed by the phase composition and the grain boundary misorientation angle. The stir zone obtained at 50 mm/min has the highest corrosion resistance, and it is followed by the base material and the stir zone obtained at 30 mm/min.
ERNiCrFe-7A is widely used to repair critical components in nuclear power systems and other advanced engineering equipment because of its excellent high-temperature performance and corrosion resistance. However, the repeated thermal cycles and residual stresses induced by multilayer, multipass welding increase the susceptibility of ERNiCrFe-7A overlays to ductility-dip cracking (DDC), thereby reducing weld integrity and structural reliability. This study systematically evaluated how the orientation of the auxiliary magnetic field affected the microstructure, grain-boundary character, mechanical properties, and DDC susceptibility of ERNiCrFe-7A overlays. For this purpose, metal inert gas (MIG) weld overlays were deposited without an auxiliary magnetic field (0 mT) and under transverse and longitudinal magnetic fields of 10 mT. The applied fields altered solidification by redistributing heat and fluid flow within the molten pool. The transverse magnetic field refined the grains and eliminated continuous grain-boundary Cr₂₃C₆. The longitudinal magnetic field generated stronger electromagnetic stirring. This stirring produced more pronounced grain refinement and microstructural homogenization while promoting dispersed grain-boundary carbide formation and intragranular (Nb, Ti)C precipitation. Electron backscatter diffraction showed that the longitudinal magnetic field increased the fractions of low-angle grain boundaries and low-Σ coincidence site lattice boundaries to a greater extent than did the transverse magnetic field. The longitudinal magnetic field also produced greater grain-boundary tortuosity. Magnetic field assistance increased hardness and improved the strength–ductility balance at both room temperature and 350 °C. Under the longitudinal magnetic field, hardness increased by 23.3% to 204.5 HV. At room temperature, the ultimate tensile strength and yield strength reached 638.2 and 368.2 MPa, respectively, while elongation increased to 48.2%. Strain-to-fracture tests demonstrated that the applied fields markedly reduced DDC susceptibility. The transverse magnetic field increased the critical strain for DDC initiation from 2% to 4%, and the longitudinal magnetic field further increased it to 6%. These improvements were attributed to the combined effects of grain-boundary network optimization, precipitate dispersion, and stress homogenization, which suppressed crack initiation and propagation.