Joachim von Zitzewitz

Joachim von Zitzewitz

Auto-generated profile, based on publicly available information

Joachim von Zitzewitz

ONWARD Medical, Lausanne, Switzerland

Research Focus & Metrics

Academic Career Length

20Years (2007-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
13 April 2021 in Sensors
Verified
Journal Article
Open access
PDF file
HPHari Prasanth
Hari Prasanth
MCMiroslav Caban
Miroslav Caban
UKUrs Keller
Urs Keller
GCGrégoire Courtine
Grégoire Courtine
AIAuke Ijspeert
Auke Ijspeert
JZJoachim von Zitzewitz
Joachim von Zitzewitz
Gait analysis has traditionally been carried out in a laboratory environment using expensive equipment, but, recently, reliable, affordable, and wearable sensors have enabled integration into clinical applications as well as use during activities of daily living. Real-time gait analysis is key to the development of gait rehabilitation techniques and assistive devices such as neuroprostheses. This article presents a systematic review of wearable sensors and techniques used in real-time gait analysis, and their application to pathological gait. From four major scientific databases, we identified 1262 articles of which 113 were analyzed in full-text. We found that heel strike and toe off are the most sought-after gait events. Inertial measurement units (IMU) are the most widely used wearable sensors and the shank and foot are the preferred placements. Insole pressure sensors are the most common sensors for ground-truth validation for IMU-based gait detection. Rule-based techniques relying on threshold or peak detection are the most widely used gait detection method. The heterogeneity of evaluation criteria prevented quantitative performance comparison of all methods. Although most studies predicted that the proposed methods would work on pathological gait, less than one third were validated on such data. Clinical applications of gait detection algorithms were considered, and we recommend a combination of IMU and rule-based methods as an optimal solution.

19 July 2017 in Science Translational Medicine
Verified
Journal Article
Closed access
PDF file
JMJean-Baptiste Mignardot
Jean-Baptiste Mignardot
CGCamille G. Le Goff
Camille G. Le Goff
RBRubia van Den Brand
Rubia van Den Brand
MCMarco Capogrosso
Marco Capogrosso
NFNicolas Fumeaux
Nicolas Fumeaux
GCGrégoire Courtine
Grégoire Courtine
A robotic harness optimizing gravity-dependent gait interactions enables natural locomotion across activities of daily living in people with spinal cord injury or stroke.

7 March 2018 in IEEE Robotics and Automation Letters
Verified
Journal Article
Closed access
MPMichiel Plooij
Michiel Plooij
UKUrs Keller
Urs Keller
BSBram Sterke
Bram Sterke
SKSalif Komi
Salif Komi
HVHeike Vallery
Heike Vallery
JZJoachim von Zitzewitz
Joachim von Zitzewitz
Body weight support (BWS) systems are widely used in gait research and rehabilitation. This letter introduces a new three-dimensional overground BWS system, called the RYSEN. The RYSEN is designed to be intrinsically safe and low power consuming, while still performing at least as well as existing BWS systems regarding human-robot interaction. These features are mainly achieved by decoupling degrees of freedom between motors: slow/high-torque motors for vertical motion and fast/low-torque motors for horizontal motion. This letter explains the design and evaluates its performance on power consumption and safety. Power consumption is expressed in terms of the sum of the positive mechanical output power of all motor axes. Safety is defined as the difference between the mechanical power available for horizontal and vertical movements and the mechanical power that is needed to perform its task. The results of the RYSEN are compared to the performance of three similar systems: a gantry, the FLOAT, and a classic cable robot. The results show that the RYSEN and a gantry consume approximately the same amount of power. The amount is approximately half the power consumed by the next-best system. For the safety, the gantry is taken as the benchmark, because of its perfect decoupling of directions. The RYSEN has a surplus of 268 W and 126 W for horizontal and vertical movements, respectively. This is significantly lower than the next-best system, which has a surplus of 1088 W and 1967 W, respectively.

29 September 2021 in Science Robotics
Verified
Journal Article
Closed access
MPMichiel Plooij
Michiel Plooij
SAS. Apte
S. Apte
UKU. Keller
U. Keller
PBP. Baines
P. Baines
BSBram T. Sterke
Bram T. Sterke
HVHeike Vallery
Heike Vallery
Device transparency, support force, and attachment are important for optimal body-weight support in gait neurorehabilitation.

12 March 2025 in Science Robotics
Verified
Journal Article
Closed access
NHNicolas Hankov
Nicolas Hankov
MCMiroslav Caban
Miroslav Caban
RDRobin Demesmaeker
Robin Demesmaeker
MRMargaux Roulet
Margaux Roulet
SKSalif Komi
Salif Komi
GCGrégoire Courtine
Grégoire Courtine
Rehabilitation robotics aims to promote activity-dependent reorganization of the nervous system. However, people with paralysis cannot generate sufficient activity during robot-assisted rehabilitation and, consequently, do not benefit from these therapies. Here, we developed an implantable spinal cord neuroprosthesis operating in a closed loop to promote robust activity during walking and cycling assisted by robotic devices. This neuroprosthesis is device agnostic and designed for seamless implementation by nonexpert users. Preliminary evaluations in participants with paralysis showed that the neuroprosthesis enabled well-organized patterns of muscle activity during robot-assisted walking and cycling. A proof-of-concept study suggested that robot-assisted rehabilitation augmented by the neuroprosthesis promoted sustained neurological improvements. Moreover, the neuroprosthesis augmented recreational walking and cycling activities outdoors. Future clinical trials will have to confirm these findings in a broader population.

1 June 2007
Verified
Conference Paper
Closed access
ADAlexander Duschau-Wicke
Alexander Duschau-Wicke
JZJoachim von Zitzewitz
Joachim von Zitzewitz
RBRaphael Banz
Raphael Banz
RRRobert Riener
Robert Riener
Functional and task-oriented robotic rehabilitation training can be improved by the interaction of the patient with real-world objects. If these objects are not directly coupled to the robot, a synchronization of robot and object is required, comparable to a calibration between the end effector of an industrial robot and a work piece. Such synchronization prevents from safety hazards and unwanted tension forces at the man-machine interface between robot and patient or patient and object. In this paper, we propose a combination of an iterative learning synchronization (ILS) and an immediate error correction (IEC) technique to automate such synchronization processes. The feasibility of these methods is demonstrated by using them to automatically synchronize the gait rehabilitation robot Lokomat with a treadmilL.