1 December 2023 in Physics of Fluids
Liquid atomization is a very complex issue, involving multiple length and time scales over several orders of magnitude. To better understand the atomization characteristics of the main injection in a lean premix prevaporize (LPP) combustor, a volume of fluid (VOF)–particle conversion algorithm Lagrangian particle tracking (LPT) coupled approach was proposed to simultaneously reproduce the primary and secondary breakup processes. A VOF model with an adaptive mesh refinement strategy was used to resolve the liquid disintegration on a large scale. The small liquid structures qualified as droplets were transformed into discrete particles based on particle conversion criteria. Next, these particles were tracked using the LPT method to simulate the secondary breakup process. The proposed coupled method used in the Eulerian/Lagrangian framework was validated against liquid jet in crossflow experimental data. The numerical results achieved good agreement with the experimental data. Finally, the proposed method was used to predict the atomization characteristics of the main injection in an LPP combustor under various aerodynamic conditions. Qualitative and quantitative information about liquid deformation and spray characteristics were obtained, which varied depending on the aerodynamic parameters.
1 December 2024 in Physics of Fluids
Pre-filming atomizers are used in low pollution center staged combustion chambers, which face high-altitude and low-temperature ignition problems during the operation of aircraft engines. By using a pre-filming atomizer, a thin liquid sheet is formed on the plate and encounters a high-velocity swirling airstream which lead to the atomization of the fuel. In this study, an experimental investigation was conducted to explore the flow characteristics and atomization characteristics of a pre-filming atomizer with low-temperature fuel. The dynamic process of the fuel atomization in the pre-filming atomizer was measured, and the fluctuation frequency, breakup length of the liquid film surface, and the spray particle size in the secondary atomization area were obtained. The results demonstrate that the atomizer flow number increases with a reduction in fuel temperature, attributed to the increased fuel density and mitigated cavitation effects. Concurrently, as the fuel temperature decreases, the surface fluctuation frequency of liquid film diminishes due to the heightened surface tension and internal viscosity of the fuel. The aerodynamic shear force reduces as the relative velocity between the fuel and air flow decreases, leading to an extended average liquid film breakup length. And the spray particle size generated in the secondary atomization area increases slightly due to the relatively minor impact of fuel temperature on atomization characteristics compared to the dominant role of aerodynamic forces. Finally, the fuel temperature mainly affects the atomization characteristics of the pre-filming atomizer by the physical properties and fuel flow rate, which is primarily represented under small air flow conditions.
1 January 2022 in SSRN Electronic Journal
An experimental study was performed on the primary breakup of a liquid sheet in a planar prefilming airblast atomizer. Using a high-speed camera, the backlighting visualization and reflection imaging were applied to record images and capture the breakup process of the liquid film. Image post-processing techniques were developed to obtain the quantitative atomization characteristics, including the surface wave frequency, film thickness, and film breakup length. In particular, the effects of aerodynamic parameters and gravity on atomization were highlighted. The results demonstrated that the aerodynamic parameters had the predominant influence on the atomization performance, whereas the effect of gravity was less important. Based on non-dimensional aerodynamic numbers, the disintegration process of the liquid film on the prefilmer was classified according to three breakup mechanisms. Additionally, correlations were derived from the experimental data and used to predict the atomization characteristics. The fitting offset of the surface wave frequency was limited to 10%, and the breakup length was limited to 15%. These predictive correlations could assist in resolving engineering issues regarding prefilming atomizers.