Yibo Wang

Yibo Wang

Auto-generated profile, based on publicly available information

Yibo Wang


Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 December 2024 in Physics of Fluids
Verified
Journal Article
Closed access
YWYibo Wang
Yibo Wang
PZPing Zhang
Ping Zhang
WLWei Li
Wei Li
YLYunpeng Liu
Yunpeng Liu
YYYingwen Yan
Yingwen Yan
Pre-filming atomizers are used in low pollution center staged combustion chambers, which face high-altitude and low-temperature ignition problems during the operation of aircraft engines. By using a pre-filming atomizer, a thin liquid sheet is formed on the plate and encounters a high-velocity swirling airstream which lead to the atomization of the fuel. In this study, an experimental investigation was conducted to explore the flow characteristics and atomization characteristics of a pre-filming atomizer with low-temperature fuel. The dynamic process of the fuel atomization in the pre-filming atomizer was measured, and the fluctuation frequency, breakup length of the liquid film surface, and the spray particle size in the secondary atomization area were obtained. The results demonstrate that the atomizer flow number increases with a reduction in fuel temperature, attributed to the increased fuel density and mitigated cavitation effects. Concurrently, as the fuel temperature decreases, the surface fluctuation frequency of liquid film diminishes due to the heightened surface tension and internal viscosity of the fuel. The aerodynamic shear force reduces as the relative velocity between the fuel and air flow decreases, leading to an extended average liquid film breakup length. And the spray particle size generated in the secondary atomization area increases slightly due to the relatively minor impact of fuel temperature on atomization characteristics compared to the dominant role of aerodynamic forces. Finally, the fuel temperature mainly affects the atomization characteristics of the pre-filming atomizer by the physical properties and fuel flow rate, which is primarily represented under small air flow conditions.

1 June 2026 in Physics of Fluids
Verified
Journal Article
Closed access
LXLongchao Xu
Longchao Xu
JZJian Zhu
Jian Zhu
YLYunpeng Liu
Yunpeng Liu
YWYibo Wang
Yibo Wang
YYYingwen Yan
Yingwen Yan
A longitudinal self-sustained combustion oscillation in a bluff-body-stabilized propane diffusion flame was experimentally suppressed using quarter-wave resonators. The baseline combustor exhibited a limit-cycle oscillation at 207.28 Hz, with a pressure amplitude of approximately 972.56 Pa and nearly in-phase pressure and heat release rate fluctuations. A nonlinear acoustic-impedance model of the QW was developed and validated by impedance-tube measurements; within the frequency range most relevant to the resonator function, most amplitude and phase errors remained within 5%. The experiments show that a single QW provides narrowband control and may either suppress or amplify the oscillation depending on its resonance frequency relative to the preexisting combustion oscillations frequency. To quantify this behavior, three nondimensional parameters were introduced: the normalized QW resonance frequency, normalized oscillation pressure amplitude, and normalized oscillation frequency. The optimal suppression cases were mainly located within −0.15 < ηfa < −0.07, whereas amplification became more likely when ηfa > −0.07. The strongest amplification occurred in case 3, where the oscillation pressure amplitude increased by 17.7%. Under the optimal 12-QW configuration, the pressure amplitude was reduced by 77.8% (13.1 dB), and the original single-mode limit cycle collapsed into weaker low-frequency components around 140 and 155 Hz. CH* dynamic mode decomposition further showed that the suppressed state was accompanied by an asymmetric projected flame-pulsation structure, which was qualitatively consistent with the simulated redistribution of transverse acoustic velocity near the resonator sidewall. These results indicate that QW suppression is governed primarily by resonator-induced acoustic-pressure-response redistribution and the associated modification of the flame–acoustic feedback loop, rather than by the sound absorption coefficient alone.