Synchrotron XPS was used to investigate a series of chemically synthesised, atomically precise gold clusters Aun(PPh3)y (n = 8, 9 and 101, y depending on the cluster size) immobilized on anatase (titania) nanoparticles. Effects of post-deposition treatments were investigated by comparison of untreated samples with analogues that have been heat treated at 200 °C in O2, or in O2 followed by H2 atmosphere. XPS data shows that the phosphine ligands are oxidised upon heat treatment in O2. From the position of the Au 4f7/2 peak it can be concluded that the clusters partially agglomerate immediately upon deposition. Heating in oxygen, and subsequently in hydrogen, leads to further agglomeration of the gold clusters. It is found that the pre-treatment plays a crucial role in the removal of ligands and agglomeration of the clusters.
Chemically made, atomically precise phosphine-stabilized clusters Au9(PPh3)8(NO3)3 were deposited on titania and silica from solutions at various concentrations and the samples heated under vacuum to remove the ligands. Metastable induced electron spectroscopy was used to determine the density of states at the surface, and X-ray photoelectron spectroscopy for analysing the composition of the surface. It was found for the Au9 cluster deposited on titania that the ligands react with the titania substrate. Based on analysis using the singular value decomposition algorithm, the series of MIE spectra can be described as a linear combination of 3 base spectra that are assigned to the spectra of the substrate, the phosphine ligands on the substrate, and the Au clusters anchored to titania after removal of the ligands. On silica, the Au clusters show significant agglomeration after heat treatment and no interaction of the ligands with the substrate can be identified.
The far infra-red absorption spectra of a series of chemically synthesised, atomically precise phosphine-stabilised gold cluster compounds have been recorded using synchrotron light for the first time. Far-IR spectra of the Au6(Ph2P(CH2)3PPh2)4(NO3)2, Au8(PPh3)8(NO3)2, Au9(PPh3)8(NO3)3, and Pd(PPh3)Au6(PPh3)6(NO3)2 clusters reveal a complex series of peaks between 80 and 475 cm−1, for which all significant peaks can be unambiguously assigned by comparison with Density Functional Theory (DFT) geometry optimisations and frequency calculation. Strong absorptions in all spectra near 420 cm−1 are assigned to the P–Ph3 stretching vibrations. Distinct peaks within the spectrum of each specific cluster are assigned to the cluster core vibrations: 80.4 and 84.1 cm−1 (Au6) 165.1 and 166.4 cm−1 (Au8), 170.1 and 185.2 cm−1 (Au9), and 158.9, 195.2, and 206.7 cm−1 (Au6Pd). The positions of these peaks are similar to those observed to occur for the neutral Au7 cluster in the gas phase (Science, 2008, 321, 674–676). Au–P stretching vibrations only occur for Au6 near 420 cm−1, although they appear near 180 cm−1 for Au6Pd and involve gold core vibrations.
1 September 2013 in International Journal of Hydrogen Energy
The interaction of SO2 with Ir/SiO2 was studied by simultaneous in situ diffuse reflectance infrared Fourier transform spectroscopy and mass spectrometry, exposing the sample to different SO2 concentrations ranging from 10 to 50 ppm in the temperature interval 200–400 °C. Evidences of adsorption of sulfur species in both absence and presence of oxygen are found. For a pre-reduced sample in the absence of oxygen, SO2 disproportionates such that the iridium surface is rapidly saturated with adsorbed S while minor amounts of formed SO3 may adsorb on SiO2. Adding oxygen to the feed leads to the oxidation of sulfide species that either (i) desorb as SO2 and/or SO3, (ii) remain at metal sites in the form of adsorbed SO2, or (iii) spillover to the oxide support and form sulfates ( ). Notably, significant formation of sulfates on silica is possible only in the presence of both SO2 and O2, suggesting that SO2 oxidation to SO3 is a necessary first step in the mechanism of formation of sulfates on silica. During the formation of sulfates, a concomitant removal/rearrangement of surface silanol groups is observed. Finally, the interaction of SO2 with Ir/SiO2 depends primarily on the temperature and type of gas components but only to a minor extent on the inlet SO2 concentration.