Vojtěch Klír

Vojtěch Klír

Auto-generated profile, based on publicly available information

Vojtěch Klír

Vehicle Center of Sustainable Mobility, Faculty of Mechanical Engineering, Czech Technical University in Prague, 16000 Prague, Czech Republic

Research Focus & Metrics

Academic Career Length

18Years (2009-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 December 2025 in International Journal of Hydrogen Energy
Verified
Journal Article
Closed access
JTJustin Thomas
Justin Thomas
IBIvan Bortel
Ivan Bortel
ŠKŠtěpán Kyjovský
Štěpán Kyjovský
OVOldřIch Vítek
OldřIch Vítek
VKVojtěch Klír
Vojtěch Klír

26 May 2022 in Aviation
Verified
Journal Article
Open access
PDF file
MČMichal Čížek
Michal Čížek
VKVojtěch Klír
Vojtěch Klír
PSPavel Steinbauer
Pavel Steinbauer
TVTomáš Vampola
Tomáš Vampola
This article presents currently obtained results from CFD analysis of the labyrinth seals of an aircraft turbine engine. The process of describing a geometry, grid for numerical calculation and boundary conditions are described. Numerical simulations were performed for the assumed boundary conditions. The presented results show total temperature differences in labyrinth seals compared to published results. An experimental verification of the CFD analysis was also performed to clarify the numerical simulation results. It was based on the labyrinth seal measurement stand. The final part of this study is dedicated to the discussion and the following possible activities on this topic.

20 April 2009 in SAE International Journal of Advances and Current Practices in Mobility
Verified
Conference Paper
Closed access
PDF file
LML'UBomír Miklánek
L'UBomír Miklánek
VKVojtěch Klír
Vojtěch Klír
MEMiloslav Emrich
Miloslav Emrich
LPLuděk Pohořelský
Luděk Pohořelský
The presented work deals with an accurate method for the EGR (Exhaust Gas Recirculation) rate determination, which is suitable for the real combustion engines equipped with the uncooled EGR system. A Thermal Balance method (further T.B.) has been proposed for this purpose. It uses differences between EGR (hot gas) and fresh charging air temperatures as a base for the EGR mass fraction determination. This method has been developed and tested on a real engine in authors' laboratory and verified using the well known CO2 method. As it is known that this method is inherently not accurate, the paper deals with a possibility how to improve the method. Measured differences between results from both methods T.B. and CO2 are within 8% in the measured operating range.