1 February 2009 in Transportation Research Part C: Emerging Technologies
17 April 2018 in Measurement Science and Technology
Generally, in railway networks, dissipated energy—and its consequences in terms of noise, ballast attrition, electromagnetic interference, etc—is considered a nuisance generated by this means of transport. Therefore, most studies are carried out with the aim of reducing it. This paper takes the opposite view and considers the particular case of the irreducible electromagnetic interference generated along an electrified line, in order to propose new applications beneficial to railway operations. At a selected representative location, wideband (ranging from 10 kHz to 1 GHz) electromagnetic field measurements are performed successively during, and not during, high speed train passages. We deduce two potential applications of these unintentional signals. At low frequency, the first proposal considers energy harvesting using the received electromagnetic interference as the source. This received energy can be converted and used to DC feed low consumption sensors to be installed along the railway infrastructure. These sensors participate in monitoring infrastructure health and in making it more resilient to internal and external stresses. At higher frequencies, for the second proposal, radiation from the catenary line and train pantograph is specifically examined at a carefully selected sub-band. The results are also studied following a time–frequency analysis, to introduce a new nondestructive inspection method of the sliding contact between the catenary line and the train pantograph. Ultimately, this technique could offer a new means of monitoring the health of both the catenary line and the pantograph.
2 October 2018 in IEEE Transactions on Antennas and Propagation
This paper describes and evaluates a new test facility able to generate different wireless multipath radiocommunication channels. It is used to recreate various electromagnetic (EM) environments, such as those inside vehicles. This test facility, in the form of a moderate volume metallic chamber, contains apertures, left opened or obstructed as required, and a variable quantity of salt water. Both are used to adjust the EM losses and to control smoothly and accurately the Delay Spread of the communication channel inside the test facility. A frequency range between 2 GHz and 3 GHz is studied. As a first step, the RMS Delay Spread is measured inside a vehicle for several locations of the receiving antenna and for different scenarios including different Line Of Sight and Non Line Of Sight paths. Then, the test facility is introduced, dimensioned and evaluated, trying to reproduce the RMS Delay Spread of each previous in-vehicle radiocommunication configuration. A comparison between the measurement data performed both in the vehicle and in the configured test facility is presented. This comparison shows a good agreement between these two sets of measurements. It demonstrates that different static wireless in-vehicle multipath channels, corresponding to various transmitting and receiving antenna configurations, can be reproduced inside the proposed prototype test facility.