A procedure based on the stacking sequences of semiconducting materials structures is proposed in order to determine the possible dislocation character of the interface steps between two different polytypes. It is next applied to the interface between the 2H and the 3C, 4H and 6H polytypes. Three different possible dislocations are found with ⅙〈2023〉, ⅓〈1010〉 and ½〈0001〉 Burgers vectors. In a high-resolution electron microscopy study of the particular case 2H-AlN/6H-SiC, only two kinds of interface step could be observed. This is in agreement with the assumption that the growth of AlN systematically starts at the wurtzite position on the surface of the substrate. One kind of interface step is observed to generate systematically an extended defect in the AlN layer which folds from the basal to the prismatic plane. Although the prismatic defect is not seen edge on, a careful study by image simulation allows one to identify a ½ 〈1011〉 fault vector contained in the fault plane. The formation of such a defect is related to the growth mode of AlN on α-SiC.
The polarity of GaN films and their AIN buffer layer grown on the (0001)Si surface of 6H-SiC by electron cyclotron resonance plasma-enhanced molecular beam epitaxy has been investigated by convergent-beam electron diffraction (CBED) and high-resolution electron microscopy (HREM). Good results were obtained in GaN layers by CBED. For the AlN buffer layers, which contain a very high density of defects, the polarity was determined by extensive HREM and image simulation investigations. In both cases, the experimental results are in good agreement with the simulations and demonstrate that the free surfaces of the GaN and AlN layers are Ga and Al terminated respectively. Moreover, (1210) prismatic planar defects observed in the AlN layers have been identified as stacking faults, and analyses carried out in different areas of the specimens have confirmed that the layers are unipolar. From crystallographic and energy considerations, it is concluded that the formation of inversion domains in nitride layers over SiC should be difficult without the presence of impurities such as O.
We report the interplay between In incorporation and strain relaxation kinetics in high-In-content InxGa1-xN (x = 0.3) layers grown by plasma-assisted molecular-beam epitaxy. For In mole fractions x = 0.13–0.48, best structural and morphological qualities are obtained under In excess conditions, at In accumulation limit, and at a growth temperature where InGaN decomposition is active. Under such conditions, in situ and ex situ analyses of the evolution of the crystalline structure with the layer thickness point to an onset of misfit relaxation after the growth of 40 nm, and a gradual relaxation during more than 200 nm, which results in an inhomogeneous strain distribution along the growth axis. This process is associated with a compositional pulling effect, i.e., indium incorporation is partially inhibited in presence of compressive strain, resulting in a compositional gradient with increasing In mole fraction towards the surface.
5 June 2009 in IEEE Transactions on Applied Superconductivity
High crystalline quality of ultra-thin NbN layers and of NbN-MgO-NbN tri-layers, epitaxially grown by DC-magnetron sputtering in the superconducting B1-cubic phase has been achieved in a reproducible way on three different orientations of sapphire substrates i.e. R-, A- and M-planes. Significant improvements such as higher Tc, higher Jc and lower resistivity have been obtained by growing un-twined (110) oriented NbN layers on M-plane orientation of sapphire. Uniform, low roughness, 3-5 nm thick films with Tc above 12 K and Jc above 5 MA/cm2 at 4.2 K were obtained. Characterizations by TEM, AFM and X-Ray diffraction evidence that growth of un-twined NbN on M-plane lead to a better epitaxy in comparison with twinned films observed on other sapphire orientations. We observe that the reduction of the substrate temperature from 600degC to 300degC during the deposition of NbN or NbN-MgO-NbN layers thicker than 20 nm prevents the nucleation of the competing HCP NbN phase. Moreover, 1.5 nm thick AlN or MgO over-layers sputtered in-situ prevent ultra-thin NbN films degradation through aging. The formation of Nb2NyO5-x ( ~ 2.2 nm) at the unprotected NbN surface and of interfacial NbO ( ~ 0.7 nm) native oxides has been observed by XPS. It is forecasted that such improvements in ultra-thin NbN films deposited uniformly on 3 and 4 inch sapphire wafers is a key in the future development of superconducting single photon detectors, THz HEB mixers and also in low noise quantum analogical and digital Josephson devices.