6 September 2020 in Advanced Electronic Materials
The accurate extraction and the reliable, repeatable reduction of graphene–metal contact resistance (RC) are still open issues in graphene technology. Here, the importance of following clear protocols when extracting RC using the transfer length method (TLM) is demonstrated. The example of back‐gated graphene TLM structures with nickel contacts, a complementary metal oxide semiconductor compatible metal, is used here. The accurate extraction of RC is significantly affected by generally observable Dirac voltage shifts with increasing channel lengths in ambient conditions. RC is generally a function of the carrier density in graphene. Hence, the position of the Fermi level and the gate voltage impact the extraction of RC. Measurements in high vacuum, on the other hand, result in dependable extraction of RC as a function of gate voltage owing to minimal spread in Dirac voltages. The accurate measurement and extraction of important parameters like contact‐end resistance, transfer length, sheet resistance of graphene under the metal contact, and specific contact resistivity as a function of the back‐gate voltage is further assessed. The presented methodology has also been applied to devices with gold and copper contacts, with similar conclusions.
17 March 2020 in IEEE Transactions on Semiconductor Manufacturing
The measurement of the contact resistance (R C ) in semiconductor devices relies on the well-established Transfer Length Method (TLM). However, an in-depth investigation on its applicability to characterize the metal-graphene contacts is still missing. In this work, a dependability analysis on the R C values extracted from several metal-graphene stacks is performed, also devising strategies to limit the large observed statistical errors and to obtain dependable results. In particular, artifacts due to an incorrect application of TLM, e.g., negative resistance values, can be eliminated. Finally, a simulation study is proposed to quantify the contribution to R C of the so-called junction resistance at the edge of the contact, that some authors in the literature invoke to explain the observed artifacts.
21 April 2015 in Microelectronic Engineering