Wenming Zhang

Wenming Zhang

Auto-generated profile, based on publicly available information

Wenming Zhang

Department of Precision Instrument, Tsinghua University, Beijing, China

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 September 2023 in IEEE Sensors Journal
Verified
Journal Article
Closed access
WZWenming Zhang
Wenming Zhang
YZYinan Zhang
Yinan Zhang
HGHaoyu Gu
Haoyu Gu
ZLZhihui Lin
Zhihui Lin
Wei QiWei Qi
Wei Qi
ZRZhang Rong
Zhang Rong
Hemispherical resonator gyroscope (HRG) is a high precision inertial sensor for measurement of rate and attitude angle, and the fused silica hemispherical resonator is key component of HRG which the ultra-low frequency split is required. During the entire fabrication process of the resonator, the imperfects of the resonators should be trimmed by evaluating the quality-factor and frequency split in real-time. Therefore, the high-precision balance method based on synchronous trimming system has been proposed in this paper, and the quality-factor, frequency split and principle-axis angle could be identified at the same time in a single test. At first, the high precision orbital parameter identification algorithm based on nonlinear least square method has been adopted, which shows the identification error of frequency split and stiffness-axis-angle is less than 3.58×10 -7 Hz and 0.0207° respectively. Then, the hardware of trimming system including vacuum chamber with ion mill and neutralizer, fiber optic interferometer and FPGA control board with the proposed identification algorithm has been implemented. Finally, the focus ion beam (FIB) etching experiment has been carried out to verify the proposed trimming method. The experimental result shows that the proposed method has excellent performance, which can reduce the frequency split of all resonators under 0.0005Hz and the best result can achieve 0.00005Hz.

28 February 2020 in IEEE Access
Verified
Journal Article
Open access
BXBowen Xing
Bowen Xing
Zhou BinZhou Bin
Zhou Bin
XZXinxi Zhang
Xinxi Zhang
WZWenming Zhang
Wenming Zhang
BHBo Hou
Bo Hou
ZRZhang Rong
Zhang Rong
Structural thermal deformation is an important factor that affects the performance of MEMS devices. The mismatch of thermal expansion coefficient (CTE) between different materials is a major source. For single center supported MEMS devices, expansion difference between device and the substrate leads to the out of plane thermal deformation of the structure, resulting in the performance deterioration. This paper presents a thermal deformation suppression chip (TDSC) for single center supporting MEMS devices. It is fabricated by the MEMS process and consists of an upper plate and a lower plate. The materials of the upper and lower plates are the same as those of the device substrate and structure respectively. The principle of TDSC to suppress thermal deformation is material symmetry design. Single center anchor is adapted to connect the upper and lower plates. Besides, the center anchor can also isolate the packaging stress generated between TDSC and package shell. In this paper, center supported quadruple mass gyroscope (CSQMG) is used to verify the effect of TDSC. Finite element simulation shows that the thermal deformation suppression effect is determined by radius of TDSC anchor, and the deformation can be suppressed to 0. The conclusion is confirmed by White light interference experiment. In addition, the experiment results also show that the TDSC effectively reduce the thermal out-of-plane deformation after packaging, which is even better than that of the gyroscope without any packaging. It is further proved that TDSC can also significantly improve the temperature performance of the CSQMG. Moreover, the TDSC has simple process steps, small chip area, low cost, and is suitable for various MEMS devices with single center anchor.