Wireless Body Area Sensor Network (WBASN) is a technology employed mainly for patient health monitoring. New research is being done to take the technology to the next level i.e. player's fatigue monitoring in sports. Muscle fatigue is the main cause of player's performance degradation. This type of fatigue can be measured by sensing the accumulation of lactic acid in muscles. Excess of lactic acid makes muscles feel lethargic. Keeping this in mind we propose a protocol THreshold based Energy-efficient FAtigue Measurement (THE-FAME) for soccer players using WBASN. In THE-FAME protocol, a composite parameter has been used that consists of a threshold parameter for lactic acid accumulation and a parameter for measuring distance covered by a particular player. When any parameters's value in this composite parameter shows an increase beyond threshold, the players is declared to be in a fatigue state. The size of battery and sensor should be very small for the sake of players' best performance. These sensor nodes, implanted inside player's body, are made energy efficient by using multiple sinks instead of a single sink. Mat lab simulation results show the effectiveness of THE-FAME.
In this study, the Taguchi Design of Experiment method was used to determine the optimal Friction Stir Welding (FSW) parameters for improving the mechanical properties of AA 2014-T6 alloy butt joints. The three most significant parameters-tool rotational speed, tool linear travel speed and tool tilt angle-were optimized using the L9 orthogonal array design. The optimal welding parameters for the maximum tensile strength were determined by analyzing the signal-to-noise (S/N) ratio. A regression model was developed for the desired responses. The optimal tensile strength was achieved at the 1000 rpm, rotational speed, 600 mm/rev welding speed, and 2 ° tool title angle. The results were confirmed using a steady-state heat transfer model generated from the COMSOL Multiphysics Finite Element software. The identified optimal conditions were verified by experimental validation tests. The experimental results were consistent with the predicted values. Analysis of variance (ANOVA) was conducted to determine the effects of individual parameters and to identify the most significant process parameter. ANOVA indicated that the most significant factor affecting the mechanical behavior of the joint was the tool rotation speed followed by the linear travel speed.