9 September 2022 in npj Quantum Materials
Hybrid nanostructures consisting of two parallel InAs nanowires connected by an epitaxially grown superconductor (SC) shell recently became available. Due to the defect-free SC-semiconductor interface and the two quasi-one-dimensional channels being close by, these platforms can be utilized to spatially separate entangled pairs of electrons by using quantum dots (QD) in the so-called Cooper pair splitting (CPS) process. The minimized distance between the QDs overcomes the limitations of single-wire-based geometries and can boost the splitting efficiency. Here we investigate CPS in such a device where strong inter-dot Coulomb repulsion is also present and studied thoroughly. We analyze theoretically the slight reduction of the CPS efficiency imposed by the Coulomb interaction and compare it to the experiments. Despite the competition between crossed Andreev reflection (CAR) and inter-wire capacitance, a significant CPS signal is observed indicating the dominance of the superconducting coupling. Our results demonstrate that the application of parallel InAs nanowires with epitaxial SC is a promising route for the realization of parafermionic states relying on enhanced CAR between the wires.
1 November 2014 in Thin Solid Films
For most thin film structures, by changing the wavelength range to fit ellipsometric spectra, the values of the fitted parameters also change to a certain extent. The reason is that compared with the ellipsometric sensitivity many thin films are vertically non-uniform. In absorbing films with significant dispersion in the used wavelength range, the penetration depth of probing light can show large variations depending on the wavelength. Consequently, the value of a fitted parameter for a certain wavelength range is a weighted sum of structural information over different depth ranges corresponding to the different wavelengths. By changing the wavelength range, the range of penetration depths can be adjusted, and the fitted values can be plotted as a function of the probed depth range calculated directly from the determined or tabulated extinction coefficients. We demonstrate the results on deposited polycrystalline thin films. The advantage of this approach over the parameterization of structural properties as a function of depth is that the wavelength scan approach requires no parameterized depth distribution model for the vertical dependence of a layer property. The difference of the wavelength scan method and the vertical parameterization method is similar to the difference between the point-by-point and the parameterized dielectric function methods over the used wavelength range. The lateral structures strongly influence the ellipsometric response, as well. One of the most remarkable effects is when the lateral feature sizes approach the wavelength of the probing light. In this case the effective medium method is not valid any more, since scattering and depolarization occurs. By scanning the wavelength range, the limit wavelength of the onset of scattering can be found, and used for the determination of the corresponding critical lateral period length
1 September 2010 in Materials Science Forum
Hydroxyapatite (HAP) is the main inorganic component of mammal bone and teeth. It is one of the few bioactive materials, which helps cell growing. The objective of this study was to fabricate hydroxyapatite-biopolimer nanofiber mats. To achieve this goal, two different suspensions were used. Approximately 1 μm diameter size fibers with large HAP agglomerates were fabricated using acetone and acetic acid. Fibers with a larger diameter size and homogenous distributed HAP particles were produced applying acetone and isopropanol. During the experiment the effect of the processing parameters: applied voltage, diameter of needle, the distance of the needle tip and the collector, flow rate was analyzed.
14 January 2003 in Physica Status Solidi (a)
1 June 2012 in Studia Slavica Academiae Scientiarum Hungaricae