In this study, co-fermentation of primary sludge (PS) or waste activated sludge (WAS) with lipids was explored to improve volatile fatty acid production. PS and WAS were used as base substrate to facilitate lipid fermentation at 20 °C under semi-aerobic conditions. Mono-fermentation tests showed higher VFA yields for PS (32-89 mgCOD gVS-1) than for WAS (20-41 mgCOD gVS-1) where propionate production was favoured. The principal component analysis showed that the base substrate had a notable influence on co-fermentation yields and profile. Co-fermentation with WAS resulted in a greater extent of oleic acid degradation (up to 4.7%) and evidence of chain elongation producing valerate. The occurrence of chain elongation suggests that co-fermentation can be engineered to favour medium-chain fatty acids without the addition of external commodity chemicals. BMP tests showed that neither mono-fermentation nor co-fermentation had an impact on downstream anaerobic digestion.
31 July 2020 in Journal of Analytical Atomic Spectrometry
As a result of their unique physical, chemical and/or biological properties, the use of engineered nanoparticles (ENPs) is growing very rapidly. Iron oxide nanoparticles (IONPs) are of particular interest owing to their magnetic properties, and thus the development of suitable methods for their characterization is essential. Inductively coupled plasma-mass spectrometry (ICP-MS) operated in single-particle (SP) mode provides different types of relevant information, such as size distribution and particle number and mass concentrations. However, the use of SP-ICP-MS becomes less straightforward when the analyte signal is subject to spectral overlap. In the case of IONPs, characterization by means of SP-ICP-MS is hindered by the occurrence of ArO+ polyatomic ions with the same nominal mass-to-charge (m/z) ratio as the most abundant Fe isotope. In this work, different approaches relying on either chemical or physical (mass) resolution, to avoid this spectral interference otherwise jeopardizing accurate results, were assessed. In the case of chemical resolution, the performance of on-mass and mass-shift approaches was evaluated using different types of quadrupole-based ICP-MS instrumentation, including single-quadrupole (SQ) and tandem ICP-MS (ICP-MS/MS) units. Physical resolution was accomplished using a new generation of sector field (SF) ICP-MS instrumentation, capable of dealing with transient signals of extremely short duration (10–100 μs dwell time), even when operated at higher mass resolution (pseudo-resolution mode). Based on the figures-of-merit obtained for the different approaches evaluated, an on-mass approach using NH3 as the reaction gas in SQ-ICP-MS, an on-mass approach using H2 as the collision/reaction gas in ICP-MS/MS and pseudo-medium resolution in SF-ICP-MS were found to be the best-suited approaches for fast interference-free monitoring of the ion signals generated by IONPs in SP mode. While the use of chemical (H2/on-mass) and physical (pseudo-medium) resolutions also provided accurate and precise results for custom-made Fe3O4 (magnetite) NPs of ≈50 nm, the use of NH3 was less successful, as it leads to an extension of the SP pulse profile and a lower signal-to-background ratio. Finally, SF-ICP-MS operated in pseudo-medium resolution mode was used for the characterization of Fe3O4 NPs synthesized electrochemically (batch and continuous operation mode).
1 May 2023 in Journal of the Electrochemical Society
The increased demand for portable electronic devices and electric vehicles has resulted in an exponential increase in lithium-ion battery (LIB) waste, and becoming in turn an important secondary source for critical metals. Electrowinning is a commonly used method to recover base and precious metals from a solution, which can also be used to recover valuable metals from spent LIBs. This study unveiled the cobalt electrochemical recovery using model Co sources in increasing amounts of ethylene glycol (EG), 67 molar %, 82 molar % and 100 molar %, in a mixture with choline chloride. The electrochemical results show that increasing the amount of EG together with a small concentration of sulfate anions, in conjunction with chloride anions, in the solution mixture favours the reduction of Co2+. This improved electrochemistry seems to be related to changes of Co2+ speciation easing the reduction process. Additionally, the nature of the Co salt has a significant impact on the recovery efficiency, morphology, and purity of the Co electrodeposit. This work will underpin the science to design safe electrolyte mixtures to enhance the electrochemical recovery of Co2+ in solution from secondary sources.