To meet the growing demand for energy, multimodal energy conversion systems, such as photoferroelectrics, are receiving increased attention. Among these, oxide perovskites like Sn substituted barium titanate exhibit enhanced piezoelectric coefficient and dielectric permittivity at room temperature compared to the parent composition. This study investigates whether these enhancements originate from intrinsic Sn incorporation or extrinsic contributions. Additionally, the impact of Sn on the electronic bandgap is examined, which is critical for multifunctional applications. A combined experimental and first-principles approach is employed to systematically analyze different Sn concentrations (0–12.5 mol. % Sn), focusing on B-site ordering in BaTiO3. The experimental analysis includes dielectric and ferroelectric measurements, diffuse reflectance spectroscopy, and photoconductivity measurements for bandgap estimations. Computational screening reveals that Sn ions repel each other and preferentially adopt second neighbor B-site positions along the Ti–O–Ti bond. While the bandgap shows minimal changes (meV range), spontaneous polarization and polarization hysteresis decrease significantly with increasing Sn content. The experimentally observed increase in piezoelectric response is thus attributed primarily to extrinsic effects on the meso- and macroscales from the domain structure and the coexistence of phases around 11 mol. % Sn, rather than to intrinsic incorporation of Sn into the perovskite lattice.
11 November 2025 in Journal of Materials Chemistry C
The domain structure of Sn-doped BaTiO 3 was examined with piezoresponse force microscopy and spatially resolved Raman spectroscopy, and derived reversible and irreversible contributions from Rayleigh analysis of the dielectric response.
2 October 2025 in Journal of the American Ceramic Society
The increasing demand for efficient, multifunctional energy conversion systems has sparked interest in light‐active polar perovskite oxides. These materials offer structural flexibility and chemical tunability, making them promising candidates for multimodal energy harvesting. In particular, photoferroelectrics enable the simultaneous harvesting of thermal, light, and mechanical energy. However, mostly room temperature properties have been studied, leaving a critical gap in understanding their behavior under varying thermal conditions. This study investigates the electromechanical properties in conjunction with crystallographic changes of photoferroelectric BaTi 1 ₋ x Sn x O 3 across a temperature range of −150°C to 150°C. Increasing Sn content reduces tetragonal distortion, shifts phase transition temperatures, and induces a multi‐phase region at higher concentrations. As a result, temperature‐dependent small‐signal measurements show changes in dielectric and piezoelectric responses, with a trend toward relaxor‐like behavior at higher Sn levels. Rayleigh analysis of stress amplitude‐dependent piezoelectric coefficient reveals enhanced properties at specific compositions, for example, 7 mol% Sn) and temperatures, attributed to an optimal balance of reversible and irreversible contributions. Further, Sn doping appears to improve thermal stability by reducing irreversible contributions. These results provide significant implications for optimizing photoferroelectric BaTiO 3 by influencing material properties through Sn doping for various applications, including energy harvesting.