28 February 2022 in Archives of Metallurgy and Materials
In this work, thermo-mechanically treated 42CrMo steel was subjected to cryogenic treatment conducted by means of orthogonal design method, followed by low-temperature tempering to investigate the effect of different parameters of cryogenic treatment on wear resistance of 42CrMo steel and to optimize parameters of cryogenic treatment for improving wear resistance. The results of hardness test and wear test show that cryogenic treatment significantly improves wear resistance with marginal changes in coefficient of friction and hardness. Specifically, cryogenic temperature has the largest impact on wear resistance of 42CrMo steel, holding time has medium impact, and the parameter of treatment cycles has the least impact. The optimum parameters of cryogenic treatment are −196°C for 12 hours with one cycle for improving wear resistance. The results of scanning electron microscopy (SEM) and X-ray diffractometry (XRD) analysis indicate that marginal changes in hardness and coefficient of friction may be owing to little amount of transformation of retained austenite, and the significant influence of cryogenic treatment on improving wear resistance of 42CrMo steel can be mainly attributed to segregation of carbon atoms promoted by cryogenic treatment resulting in more precipitation of carbides in subsequent tempering.
8 January 2020 in Metrology and Measurement Systems
1 August 2022 in Metrology and Measurement Systems
In order to guarantee the accuracy of turntable angle measurement, a real-time compensation method for turntable positioning precision based on harmonic analysis is proposed in this paper. Firstly, the principle and feasibility of the real-time compensation method are analysed, and a detailed description of harmonic compensation is provided herein. Secondly, we analyse the relationships between the surface number of the polygon with the compensation order of the harmonic function and its corresponding compensation accuracy. The effects of the iterations number and the data width on calculation accuracy in the coordinate rotation digital computer (CORDIC) algorithm are analysed and the quantization models of the approximation error and rounding error of the CORDIC algorithm are established. Then, the calculation of the harmonic error function and real-time compensation processes are implemented on a field programmable gate array (FPGA) chip. The resource occupation and time delay of the phase angle calculation and the harmonic component calculation are discussed separately. Finally, the validity of the harmonic compensation method is proven through comparing the compensation effect with that of linear interpolation and the polynomial compensation method. The influences of the compensation order, the iterations number and the data width on the compensation results are demonstrated by simulation. A test platform with a laboratory-made FPGA circuit is built to evaluate the effect of real-time compensation with the harmonic function and the positioning error compensation can be performed within 760 ns. The results confirmed the effectiveness of the harmonic compensation method, revealing an improvement of the positioning precision from 54.21 to 1.63 , equivalent to 96.99% reduction in positioning error.
15 September 2023 in Archives of Metallurgy and Materials
The machining residual stress produced in the cutting process of aluminum alloy parts can easily lead to a scrap of the processed parts. In order to reduce the residual stress of aluminum alloy in the milling process, based on the Taguchi-Grey relational approach, the effects of different milling parameters on the residual stress and surface roughness of 2A12 aluminum alloy were studied. To reduce the residual stress and surface roughness of 2A12 aluminum alloy, optimized milling parameters were obtained. To further reduce the milling residual stress of 2A12 aluminum alloy, the samples processed by the optimized milling parameters were treated by cryogenic treatment and artificial aging. The residual stress of the sample was measured by the blind hole drilling method, and the evolution mechanism of the microstructure to reduce the machining residual stress was revealed. The results show that the combination of deep cooling treatment and oil bath aging can effectively reduce the residual stress on the machined surface of the aluminum alloy and facilitate a more uniform distribution of the residual stress inside the specimen. The effect of the coarse second phase on the residual stress in the microstructure is not significant, and the fine and diffusely distributed precipitation phase is beneficial to the reduction of the residual stress in the aluminum alloy.