Ute Weckmann

Ute Weckmann

Auto-generated profile, based on publicly available information

Ute Weckmann

GFZ Helmholtz Centre for Geosciences Potsdam Germany

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 September 2016 in Geophysical Journal International
Verified
Journal Article
Closed access
PDF file
NMNaser Meqbel
Naser Meqbel
UWUte Weckmann
Ute Weckmann
GMGerard Muñoz
Gerard Muñoz
OROliver Ritter
Oliver Ritter
We report on a study to explore the deep electrical conductivity structure of the Dead Sea Basin (DSB) using magnetotelluric (MT) data collected along a transect across the DSB where the left lateral strike-slip Dead Sea transform (DST) fault splits into two fault strands forming one of the largest pull-apart basins of the world. A very pronounced feature of our 2-D inversion model is a deep, subvertical conductive zone beneath the DSB. The conductor extends through the entire crust and is sandwiched between highly resistive structures associated with Precambrian rocks of the basin flanks. The high electrical conductivity could be attributed to fluids released by dehydration of the uppermost mantle beneath the DSB, possibly in combination with fluids released by mid- to low-grade metamorphism in the lower crust and generation of hydrous minerals in the middle crust through retrograde metamorphism. Similar high conductivity zones associated with fluids have been reported from other large fault systems. The presence of fluids and hydrous minerals in the middle and lower crust could explain the required low friction coefficient of the DST along the eastern boundary of the DSB and the high subsidence rate of basin sediments. 3-D inversion models confirm the existence of a subvertical high conductivity structure underneath the DSB but its expression is far less pronounced. Instead, the 3-D inversion model suggests a deepening of the conductive DSB sediments off-profile towards the south, reaching a maximum depth of approximately 12 km, which is consistent with other geophysical observations. At shallower levels, the 3-D inversion model reveals salt diapirism as an upwelling of highly resistive structures, localized underneath the Al-Lisan Peninsula. The 3-D model furthermore contains an E–W elongated conductive structure to the northeast of the DSB. More MT data with better spatial coverage are required, however, to fully constrain the robustness of the above-mentioned off-profile features.

1 March 2018 in Tectonophysics
Verified
Journal Article
Closed access
GMGerard Muñoz
Gerard Muñoz
UWUte Weckmann
Ute Weckmann
JPJosef Pek
Josef Pek
SKSvětlana Kováčiková
Světlana Kováčiková
RKRadek Klanica
Radek Klanica

1 June 2020 in Geophysical Journal International
Verified
Journal Article
Open access
PDF file
JCJ Cruces-Zabala
J Cruces-Zabala
ORO Ritter
O Ritter
UWU Weckmann
U Weckmann
KTK Tietze
K Tietze
MSM Schmitz
M Schmitz
SUMMARY: The Caribbean and South American tectonic plates bound the north-eastwards expulsion of the North Andean Block in western Venezuela. This complex geodynamic setting resulted in the formation of major strike-slip fault systems and sizeable mountain chains. The 100-km-wide Mérida Andes extend from the Colombian/Venezuelan border to the Caribbean coast. To the north and south, the Mérida Andes are bound by hydrocarbon-rich sedimentary basins. Knowledge of lithospheric structures, related to the formation of the Mérida Andes, is limited though, due to a lack of deep geophysical data. In this study, we present results of the first broad-band magnetotelluric profile crossing the Mérida Andes and the Maracaibo and Barinas–Apure foreland basins on a length of 240 km. Geoelectrical strike and dimensionality analysis are consistent with 1-D or 2-D subsurface structures for the sedimentary basins but also indicate a strong 3-D setting for the Mérida Andes. Using a combination of 2-D and 3-D modelling we systematically examined the influence of 3-D structures on 2-D inversions. Synthetic data sets derived from 3-D modelling allow identification and quantification of spurious off-profile features as well as smoothing artefact due to limited areal station coverage of data collected along a profile. The 2-D inversion models show electrically conductive basins with depths of 2–5 km for the Barinas-Apure and 2–7 km for the Maracaibo basins. A number of resistive bodies within the Maracaibo basin could be related to active deformation causing juxtaposition of older geological formations and younger basin sediments. The most important fault systems of the area, the Boconó and Valera Faults, cross-cut the Mérida Andes in NE–SW direction along its strike on a length 400 km and N–S direction at its centre on a length 60 km, respectively. Both faults are associated with subvertical zones of high electrical conductivity and sensitivity tests suggest that they reach depths of up to 12 km. A sizeable conductor at 50 km depth, which appears consistently in the 2-D sections, could be identified as an inversion artefact caused by a conductor east of the profile. We speculate the high conductivity associated with the off-profile conductor may be related to the detachment of the Trujillo Block. Our results partially support the ‘floating orogen hypothesis’ developed to explain the geodynamic evolution of western Venezuela and they highlight the relevance of the Trujillo Block in this process.

15 May 2023
Verified
Conference Paper
Open access
APAnna Platz
Anna Platz
UWUte Weckmann
Ute Weckmann
CPCedric Patzer
Cedric Patzer
The Radio-Magnetotelluric (RMT) method is a geophysical near-surface imaging technique with a broad range of possible applications. In 2020, the GFZ Potsdam has acquired a newly developed horizontal magnetic dipole transmitter that allows the application of the RMT method even in regions with an insufficient coverage of radio transmitters which normally serve as source signal. First controlled-source RMT measurements were conducted at three different locations in Chile in 2020. Further measurements were recently conducted in Ireland. As we are able to store the raw time series, we have full control over the subsequent data processing. The processing tools at GFZ include the modular processing suite EMERALD, which was originally designed for MT processing, but has recently been adapted to process RMT data. One main difference is that in RMT the transmitter data is considered as signal, while in natural source MT this would be regarded as electromagnetic noise that needs to be removed using automated robust statistical approaches. However, processing the entire time series in an automated manner has a large drawback: The different emitted frequencies are transmitted in a sweep implying that only a smaller fraction of the time series contains the required signal for a particular target frequency and leading to an unfavourable signal-to-noise ratio. Since it is technically impossible to have the same time base for the data logger and the transmitter with an accuracy of a few nanoseconds, an automated detection scheme is required to find time segments that contain the transmitter signal. Usually, several Gigabytes of raw time series are collected during field measurements, making manual editing and supervision of the time series virtually impossible. However, a careful selection of appropriate time segments is essential for the success of the data processing. To address the challenge, machine learning algorithms have a high potential to solve both problems. Initial experience was gained with a recurrent neural network approach in order to identify suitable time segments (Patzer & Weckmann, EMTF 2021 – conference contribution and personal communication). However, many questions remained open, e.g. if other machine learning algorithms can result in better performances, which machine learning algorithms are in principle suitable for the characteristics and properties of RMT time series and which parameters should be used as input variables (features) for the algorithms. A large number of machine learning algorithms exist, which can be divided into different groups according to their operating principle and their activity fields. We will test unsupervised methods, especially for clustering the data, to identify a set of suitable input variables. Subsequently, we will use these features to train supervised algorithms as logistic regression, support vector machine and different kinds of neural networks to find the best performing algorithm. We will mainly use the RMT data from Chile within the training process. Furthermore, we will test if the trained algorithm is applicable to other new data sets measured at different locations (e.g. Ireland) and/or with different equipment.

4 March 2021
Verified
Other
Open access
UWUte Weckmann
Ute Weckmann
APAnna Platz
Anna Platz
BABasel Aleid
Basel Aleid
GWGregor Willkommen
Gregor Willkommen
JMJohannes Mair
Johannes Mair
PRPaula Rulff
Paula Rulff
The Bohemian Massif represents the easternmost part of the geodynamically active European Cenozoic Rift System. This region hosts the contact between three tectonic units of the Variscan Belt, the NE-SW trending Eger Rift and the NNW-SSE striking Marianské Lázne fault. It is characterised by ongoing magmatic processes in the intra-continental lithospheric mantle, repeated earthquake swarms, extensive CO2 degassing in mineral springs and mofettes and the presence of Quaternary volcanoes. While the ICDP drilling programme utilizes information gathered within shallow boreholes in the region, we applied the Magnetotelluric (MT) method to obtain site characterizations in the vicinity of the proposed drill sites. The electrical conductivity has proven to be an important parameter to image the above-mentioned tectonic from the lower crust to the shallow subsurface as well as on a regional and a local scale. Here, we present 2D and 3D inversion models of different MT and Radio-MT (RMT) experiments to study e.g. the Hartouŝov mofette fields, the Quaternary scoria cones, the regional faults and their interplay. Thereby the experiments were designed that we can use lower frequency data from MT to support shallow 3D inversions of e.g. the scoria cones in the regions. The most prominent large-scale conductivity features map channels from the lower crust to the surface possibly forming pathways for fluids into the region of earthquake swarms, mofette fields and know spas. However, the locations of the scoria cones seem to be bound to regional fault zones.

4 March 2021
Verified
Other
Open access
JCJosé Cruces
José Cruces
OROliver Ritter
Oliver Ritter
UWUte Weckmann
Ute Weckmann
KTKristina Tietze
Kristina Tietze
NMNaser Meqbel
Naser Meqbel
MSMichael Schmitz
Michael Schmitz
The Mérida Andes are a 100 km wide mountain chain that extends from the Colombian/Venezuelan border to the Caribbean coast. To the north and south, the Mérida Andes are bound by hydrocarbon-rich sedimentary basins. Uplift of the mountains started in the late Miocene due to oblique convergence of the Caribbean and South American tectonic plates and the north-eastwards expulsion of the North Andean Block (NAB). This tectonic interaction fostered major strike-slip fault systems, with associated high seismicity, and the partitioning of the North Andean Block into smaller tectonic units, whose interaction accelerated the uplift of the Mérida Andes since the Plio-Pleistocene.We present the three-dimensional inversion results of broadband magnetotelluric (MT) data from 72 sites gathered along a 240 km long profile across the central part of the MA, the Maracaibo (MB), and Barinas-Apure (BAB) foreland basins. Directionality and dimensionality analyses suggested 3D structures for the MA section, with the induction vectors indicating off-profile structures, particularly at long periods. Since the distribution of sites predominantly along a single profile can have adverse effects on the outcome of the 3D inversion, we rigorously tested all model features for robustness and excluded artefacts.One of the main findings is a deep connection (> 10km) between the most prominent faults of the MA, the Valera and Boconó fault systems, with a deep off-profile conductor to the east of our profile. We interpret this conductive structure as a detachment surface of the Trujillo Block, which is part of the NAB and whose expulsion to the NE significantly influences the present-day geodynamic evolution of western Venezuela. A conductive zone under the Maracaibo Basin correlates spatially with the location of a Bouguer low. Both geophysical anomalies may be caused by a SE tilt of the Maracaibo Triangular Block under the Mérida Andes, bound by the north-western thrust system which could reach depths of 30 km.