Relieving unwanted strain: Although the α-phase of formamidinium lead iodide (FAPbI 3 ) has a suitable bandgap for use in solar cells, it must be stabilized with additional cations. These compositions can adversely affect the bandgap and produce lattice strain that creates trap sites for charge carriers. Kim et al. found that substituting small, equimolar amounts of cesium and methylenediammonium cations for formamidinium reduced the lattice strain and trap densities. The enhancement in open-circuit voltage led to a certified power conversion efficiency of 24.4%, and encapsulated devices retained 90% of their initial efficiency after 400 hours of maximal power point operating conditions. Science , this issue p. 108
Maintaining the bandgap: The bandgap of the black α-phase of formamidinium-based lead triiodide (FAPbI 3 ) is near optimal for creating high-efficiency perovskite solar cells. However, this phase is unstable, and the additives normally used to stabilize this phase at ambient temperature—such as methylammonium, caesium, and bromine—widen its bandgap. Min et al. show that doping of the α-FAPbI 3 phase with methylenediammonium dichloride enabled power conversion efficiencies of 23.7%, which were maintained after 600 hours of operation. Unencapsulated devices had high thermal stability and retained >90% efficiency even after annealing for 20 hours at 150°C in air. Science , this issue p. 749
The preferential growth of α‐phase formamidinium perovskite (α‐FAPbI3) at low temperatures can be achieved with the incorporation of chloride‐based additives, with methylammonium chloride (MACl) being the most common example. However, compared to other less‐volatile chloride additives, MACl only remains in the growing perovskite film for a short time before evaporating during annealing, primarily influencing the early stages of film formation. In addition, evaporation of MACl as methylamine (MA0) and HCl can introduce a side reaction between MA0 and formamidinium (FA), undermining the compositional purity and phase stability of α‐FAPbI3. In this study, it is demonstrated that addition of iodine (I2) into the FAPbI3 precursor solution containing MACl suppresses the MA‐FA side reaction during annealing. Additionally, MACl evaporation is delayed owing to strong interaction with triiodide. The added I2 facilitates spontaneous growth of α‐FAPbI3 prior to annealing, with an improved bottom morphology due to the formation of fewer byproducts. Perovskite solar cells derived from an I2‐incorporated solution deliver a champion power conversion efficiency of 25.2% that is attributed to suppressed non‐radiative recombination.
5 September 2024 in Energy & Environmental Science
The defect density on the top surface of the perovskite thin film was significantly higher than that in the bulk. A trimming solvent treatment removed the defective top surface, substantially reducing the defect concentration and strain.
Substrates or encapsulants in soft and stretchable formats are key components for transient, bioresorbable electronic systems; however, elastomeric polymers with desired mechanical and biochemical properties are very limited compared to non-transient counterparts. Here, we introduce a bioresorbable elastomer, poly(glycolide-co-ε-caprolactone) (PGCL), that contains excellent material properties including high elongation-at-break (< 1300%), resilience and toughness, and tunable dissolution behaviors. Exploitation of PGCLs as polymer matrices, in combination with conducing polymers, yields stretchable, conductive composites for degradable interconnects, sensors, and actuators, which can reliably function under external strains. Integration of device components with wireless modules demonstrates elastic, transient electronic suture system with on-demand drug delivery for rapid recovery of post-surgical wounds in soft, time-dynamic tissues.