1 December 2017 in International Journal of Geomechanics
Soil arching is a phenomenon describing stress redistribution due to relative movement between adjoining portions. It commonly exists when soil interacts with structure elements, such as tunnels, retaining walls, buried structures, and piles in pile-supported embankments. A yielding or ultimate state of soil (i.e., the shear stress in soil is equal to its shear strength) is mostly assumed in analytical models for soil arching. In reality, the level of shear stress and the shape of the slip surface in the soil depend on the magnitude of relative movement of the soil. In this study, a custom-made trapdoor test box was used to investigate the progressive development of soil arching with the trapdoor displacement. The dimensions of the test box was 1.76 m long, 0.46 m wide, and 1.48 m high, whereas the trapdoor had dimensions of 0.36 m wide and 0.46 m long. Earth pressures were installed on the top and sides of the trapdoor to monitor the development of soil arching with the displacement of the trapdoor. Furthermore, data from five references available in the literature were adopted to evaluate the progressive development of soil arching with the displacement for different geotechnical applications. Terzaghi’s method was used to calculate the two-dimensional soil arching ratios (i.e., the measured earth pressure divided by the overburden pressure) in all cases in this study using three different values of lateral earth-pressure coefficient (K), and the results were compared with the measured results. Terzaghi’s method calculated the soil-arching ratios reasonably well when the trapdoor displacement was equal to or larger than 10% of the trapdoor width. To facilitate the application of progressive development of soil arching with displacement in engineering practice, a simplified ground reaction curve (GRC) was proposed as three straight lines to represent the progressive development of two-dimensional soil arching with relative displacement. The methods for determining four required parameters were provided, and the proposed method was verified using three trapdoor test results from both this study and the literature.
1 January 2019 in Journal of Geotechnical and Geoenvironmental Engineering
Soil arching is one of the most important mechanisms in piled embankments. To investigate the development of soil arching in piled embankments, 14 unreinforced and 8 geosynthetic-reinforced model tests were carried out using a two-dimensional (2D) multitrapdoor test setup with analogical soil. This study revealed that basal geosynthetic reinforcement changed the three deformation patterns into two development patterns with concentric elliptical arches under the same conditions. The stress reduction ratios (defined as the ratio of the average pressure on the trapdoor at a certain settlement to the initial pressure on the trapdoor at zero settlement) corresponding to the three deformation patterns in the unreinforced tests were distinctively different. The change of the stress reduction ratio during the settlement of the subsoil also showed how basal reinforcement affected soil arching in piled embankments. The geosynthetic with lower tensile stiffness resulted in more soil arching than that with higher tensile stiffness.
1 August 2012 in International Journal of Geomechanics
The geosynthetic-reinforced pile-supported embankment is one of the favorable ground improvement techniques used in the construction of earth structures over a compressible soil when limited construction time is available and limited deformation is permissible. Various methods are available for the design of the geosynthetic-reinforced platform based on various load transfer mechanisms from the embankment to the piles and the compressible soil. The existence of the geosynthetic layer makes the mechanisms more complex. This study focuses on the behavior of geogrid-reinforced embankments over piles compared with the behavior of unreinforced embankments. The numerical simulations of the unreinforced and reinforced pile-supported embankments were conducted using the discrete element method (DEM). The embankment fill was simulated using unbonded graded aggregates of diameters ranging from 9.2 to 20.8 mm and the geogrid was simulated using bonded particles. This study investigated the changes of vertica...
1 November 2011 in Journal of Materials in Civil Engineering
Recycled asphalt pavement (RAP) has been increasingly used as an energy efficient and environmentally friendly paving material and is currently the most reused and recycled material in the United States. RAP has been used in new hot mix asphalt (HMA) mixtures and in base courses for pavement construction. When RAP is used as a base course material, the presence of asphalt in RAP may cause excessive deformation under traffic loading. Geocell, three-dimensional (3D) polymeric geosynthetic cells, was proposed in this study to minimize the deformation by confining the RAP material. Full-scale accelerated pavement tests were conducted to evaluate the effect of geocell reinforcement on RAP base courses over weak subgrade. Two types of RAP were used and a total of seven geocell-reinforced and unreinforced RAP sections were tested under full-scale traffic loads. The road sections were excavated and examined after each moving wheel test. The benefits of geocell reinforcement were evaluated in rut depths for a spec...
1 August 2009 in Journal of Geotechnical and Geoenvironmental Engineering
Geosynthetic-reinforced column-supported (GRCS) embankments have increasingly been used in the recent years for accelerated construction. Numerical analyses have been conducted to improve understanding and knowledge of this complicated embankment system. However, most studies so far have been focused on its short-term or long-term behavior by assuming an undrained or drained condition, which does not consider water flow in saturated soft soil (i.e., consolidation). As a result, very limited attention has been paid to a settlement-time relationship especially postconstruction settlement, which is critical to performance of pavements on embankments or connection between approach embankments and bridge abutments. To investigate the time-dependent behavior, coupled two-dimensional mechanical and hydraulic numerical modeling was conducted in this study to analyze a well-instrumented geotextile-reinforced deep mixed column-supported embankment in Hertsby, Finland. In the mechanical modeling, soils and DM columns were modeled as elastic-plastic materials and a geotextile layer was modeled using cable elements. In the hydraulic modeling, water flow was modeled to simulate generation and dissipation of excess pore water pressures during and after the construction of the embankment. The numerical results with or without modeling water flow were compared with the field data. In addition, parametric studies were conducted to further examine the effects of geosynthetic stiffness, column modulus, and average staged construction rate on the postconstruction settlement and the tension in the geosynthetic reinforcement.
1 April 2016 in Geosynthetics International
Geosynthetic encasement of individual stone columns can provide additional confinement to the columns thus increasing their load capacities and reducing lateral and vertical deformations. Most of past studies have been focused on the load capacities and settlements (i.e. vertical deformations) of the encased stone columns. However, the load transfer mechanism and the lateral bulging deformation pattern of the encased stone columns are not thoroughly understood. In the present study, four series of laboratory model tests in a large-scale testing tank were performed to investigate the effect of geogrid encasement on the lateral and vertical deformations of stone columns installed in a clay bed. For comparison purposes, ordinary stone columns were also tested and evaluated. The main objective of this research is to investigate the lateral and vertical deformation patterns of the encased stone columns and the reinforcement mechanisms of the geogrid encasement with different encasement lengths. In addition, the stress–strain characteristics of the encasement were measured and analysed. The test results show that the ultimate load capacity of the soft soil was greatly increased by the geogrid-encased stone columns. The effective length of the encasement was three to four times of the diameter of stone columns based on the consideration of performance and economy. In comparison with the analytical solution based on the unit cell concept with full encasement of columns, the experimental tests on composite foundations with partially encased columns, which allowed lateral deformations of columns and soils and slippage along the column-soil interfaces (geogrid–soil, stone column–geogrid, and stone column–soil if the column is not encased), resulted in larger settlements, especially at higher vertical pressures.