In the presented work, the characterization of plates using zero group velocity Lamb modes is discussed. First, analytical expressions are shown for the determination of the k-ω location of the zero group velocity Lamb modes as a function of the Poisson's ratio. The analytical expressions are solved numerically and an inverse problem is formulated to determine the unknown wave velocities in plates of known thickness. The analysis is applied to determine the elastic properties of tungsten and aluminum plates based on the experimentally measured frequency spectra.
1 July 2015 in The Journal of the Acoustical Society of America
The excitability of zero group velocity (ZGV) Lamb waves using a pulsed laser source is investigated experimentally and through numerical simulation. Experimentally, a laser based ultrasonic technique is used to find the optical spot size on the sample surface that allows an optimal coupling of the optical energy into the ZGV mode. Numerical simulations, using the time domain finite differences technique, are carried out to model the thermoelastic generation process by laser irradiation and the propagation of the generated acoustic waves. The experimental results are in good agreement with the numerical predictions. The experimentally and numerically obtained responses of the plate are investigated by a short-time Fourier transform. The responses show that the source diameter does not affect the fundamental behavior of the temporal decay of the ZGV mode.
We propose a method to simultaneously determine the thickness of an isotropic plate together with the longitudinal and shear elastic wave velocities of its material. The method requires knowledge of the frequencies of two zero-group-velocity Lamb modes and one respective wavenumber. These quantities are defined by the Rayleigh-Lamb equations, which we use in an inverse problem to obtain the properties of the plate. Experimentally, the frequencies of zero-group-velocity points can be obtained at high precision by measuring the elastic response spectrum of a plate, using laser-ultrasound techniques. By shaping the excitation laser spot with a spatial light modulator, we extend this to enable measurements of the corresponding wavenumber. The introduced method is demonstrated for a homogeneous tungsten and an aluminium plate.
We present a laser-ultrasound measurement technique which combines adjustable spatial and temporal modulation of the excitation laser beam. Our method spreads the intensity of an amplitude modulated continuous wave laser over a micro-scale pattern on the sample surface to excite surface acoustic waves. The excitation pattern consists of parallel, equidistant lines and the waves generated from the individual lines interfere on the sample surface. Measurement is done in the spatial-temporal frequency domain allowing the direct determination of dispersion relations. The technique performs with high signal-to-noise-ratios and low peak power densities on the sample.
This article elaborates on the crossing points of the frequency–wavenumber branches for the symmetric and anti-symmetric Lamb modes in a homogeneous plate. It is shown both theoretically as well as experimentally that at these crossing points either the normal or the longitudinal components of modal displacement attain an extreme value, i.e. a maximum or it vanishes. This behavior is assessed herein using a method due to Mindlin, who showed that the dispersion curves for a plate with mixed boundary conditions – which are associated with uncoupled shear and dilatational modes – provide bounds to the spectral lines of the free plate. Therefore, a subset of the crossing points of the symmetric and antisymmetric Lamb modes for a free plate coincide with the crossing points for a plate with mixed boundary conditions.