Jiande Wang

Jiande Wang

Auto-generated profile, based on publicly available information

Jiande Wang

Hunan University State Key Laboratory of Advanced design and manufacturing for vehicle body, Changsha, Hunan China

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 September 2018 in IEEE Transactions on Vehicular Technology
Verified
Journal Article
Closed access
YLYunfeng Liu
Yunfeng Liu
YZYunshan Zhou
Yunshan Zhou
JWJiande Wang
Jiande Wang
DQDaohai Qu
Daohai Qu
FZFeitie Zhang
Feitie Zhang
An electric oil pump (EOP) for the hydraulic system of a continuously variable transmission (CVT)-based hybrid electric vehicle is developed, by considering the arrangement of structures and the realization of electric drive mode (EDM). The basic parameters required for the EOP motor are obtained by analyzing the flow rate and pressure of CVT. Then, the EOP motor is designed and developed. Current-pressure characteristics of different solenoid valves are measured and analyzed for designing the CVT speed ratio controller. The speed ratio controller, pressure controller, and EOP control strategy are analyzed in detail with the use of EOP as the power source of the hydraulic system only. The performances of the speed ratio controller and the EOP control strategy are verified on a test bench. Experimental results show that the steady-state error of the speed ratio controller is minimal, and the response time of speed ratio from 0.7 to 1.4 can be shortened approximately 0.49 s to 1.40 s by increasing the EOP speed from 1000 rpm to 2500 rpm. The actual EOP speed can also be adjusted by the demand of system flow to save the maximum amount of energy.

2 November 2014 in Advances in Mechanical Engineering
Verified
Journal Article
Open access
JWJiande Wang
Jiande Wang
YZYunshan Zhou
Yunshan Zhou
QLQuan Li
Quan Li
A communication model of diagnostic network and implementation of unified diagnostic services (UDS) based on controller area network (CAN) bus are presented in this paper, and fault diagnostic function of transmission control unit (TCU), USB- (universal serial bus-) CAN hardware and software modules, and fault diagnostic software based on personal computer (PC) are designed. Model diagnostic method is applied on ratio control, and fault diagnostic system is tested in vehicle.