26 February 2019 in Journal of Raman Spectroscopy
1 November 2017 in Optical Materials
19 May 2017 in Instrumentation Science & Technology
We have developed a novel way of controlling parameters in reactors using flue gases from pulse combustion as a direct source of heat and as a means of transport of particulate materials synthesized in a slightly reductive environment or oxidative environment. The reactor is used for a spray pyrolysis synthesis of materials or the sintering of different ceramic powders. The reactor is heated directly, which means reduced energy losses, and the enhanced drying reported using pulse combustion is implemented for faster reaction. A slightly reductive atmosphere is maintained by combusting a stoichiometric fuel and air mixture and adding acetylene to the flue gas flow. Reaction conditions must be carefully controlled; this is achieved by influencing the characteristic times of the pulse combustion and changing the frequency of combustion and with it the temperature and flue gas composition in the reactor. The frequency is changed by nitrogen dilution of burning gas, influencing the mixing of the combustible mixture with hot flue gases and damping of frequencies with a secondary Helmholtz resonator. The frequency of pressure oscillations in the combustor should be the same as one of the harmonic frequencies of the reactor pipe to reach an acoustic resonance. In this work, the frequency of pulse combustion was altered in such a way that resonance was established with the reactor pipe and that a suitable reaction environment was obtained. With good control over all parameters, we were able to synthesize different Li-ion cathode materials, such as LiFePO4 and Li(NixMnyCoz)O2.
1 September 2017 in Journal of Power Sources
1 January 2018 in Optical Materials
26 August 2019 in Journal of Applied Physics
Lithium iron phosphate (LiFePO4, LFP) is one of the widely used cathode materials for rechargeable lithium ion batteries. LFP batteries are widely used for electric vehicles and backup power due to their important advantages such as low cost, lifetime, efficiency, and reliability. There are still several technical challenges that need to be addressed: the increase of energy density or further reduction of their final cost. This paper concerned with the characterization of carbon coated LiFePO4 nanopowder cathode materials produced under different conditions by pulse combustion for providing energy to the reactor for the synthesis. The reactor was built according to the principles of the thermoacoustic burner on the basis of the Helmholtz resonator. The investigated nanopowders are synthesized by complete and incomplete combustion and calcined at 700 °C. The obtained samples were characterized by X-ray diffraction, Fourier transform infrared, Raman, and Mössbauer spectroscopy. Observed low-temperature magnetic phase transitions definitively identified the crystal phases. The morphology of samples was controlled by scanning electron microscopy. The aim of this work is to show that it is possible to achieve a desired crystal phase by pulse combustion in a relatively cheap and fast way. The extremely rapid synthesis of almost pure phase material is possible due to the reduction in size of interacting particles and to an enormous number of collisions between them as a result of strong turbulent flow associated with explosive combustion.