18 December 2020 in Science Advances
Time-resolved x-ray microscopy and microwave measurements reveal the operation of submicrometer spin wave majority gates.
8 March 2022 in Scientific Reports
We derive a lumped circuit model for inductive antenna spin-wave transducers in the vicinity of a ferromagnetic medium. The model considers the antenna’s Ohmic resistance, its inductance, as well as the additional inductance due to the excitation of ferromagnetic resonance or spin waves in the ferromagnetic medium. As an example, the additional inductance is discussed for a wire antenna on top of a ferromagnetic waveguide, a structure that is characteristic for many magnonic devices and experiments. The model is used to assess the scaling properties and the energy efficiency of inductive antennas. Issues related to scaling antenna transducers to the nanoscale and possible solutions are also addressed.
29 January 2021 in Physical Review Applied
Exploring the third dimension in magnonic systems is essential for the investigation of alternative physical phenomena and for the control of spin-wave propagation at the nanoscale. Here, the characteristics of spin waves in vertical meander-shaped thin films consisting of nanosegments located at 90° angles with respect to each other are investigated by Brillouin-light-scattering spectroscopy over four Brillouin zones in reciprocal space. We reveal the dispersion relations and the periodic character of several dispersive branches as well as alternating frequency bands, where spin waves are allowed or forbidden to propagate. Between each couple of successive modes, frequency band gaps exist only for wave numbers k = 2mπ/a, where m is an integer number and a is the size of the meander unit cell, whereas the spectra show propagating modes in the orthogonal film segments for all the other wave numbers. Micromagnetic simulations and analytical calculations are used to understand and explain the results in terms of the mode spatial localization and symmetry. We show that the width and the center frequency of the magnonic band gaps can be controlled by changing the geometrical parameters of the meander-shaped film. The investigated samples behave as three-dimensional waveguides where spin waves propagate in the film segments located at 90° angles with respect to each other, thus making possible vertical spin-wave transport for multilayer magnonic architectures and signal processing.
19 April 2021 in Applied Physics Letters
In this work, we investigate the spin-wave propagation in three-dimensional nanoscale CoFeB/Ta/NiFe meander structures fabricated on a structured SiO2/Si substrate. The magnonic band structure has been experimentally determined by wavevector-resolved Brillouin light scattering spectroscopy and a set of stationary modes interposed by two dispersive modes of Bloch type have been identified. The results could be understood by micromagnetic and finite element simulations of the mode distributions in both real space and the frequency domain. The dispersive modes periodically oscillate in frequency over the Brillouin zones and correspond to modes, whose spatial distributions extend over the entire sample and are either localized exclusively in the CoFeB layer or the entire CoFeB/Ta/NiFe magnetic bilayer, with in-phase precession of the dynamic magnetization in the two layers. Low-frequency stationary modes are concentrated in horizontal segments of the topmost NiFe layer with sizeable amplitudes in the vertical CoFeB and NiFe segments and out-of-phase precession. The findings are compared with those of single-layer CoFeB meander structures with the same geometry parameters, which reveals the influence of the dipolar coupling between the two ferromagnetic layers on the magnonic band structure.
21 June 2021 in Physical Review B
We develop a generic all-inductive procedure to measure the band structure of spin waves in a magnetic thin stripe. In contrast to existing techniques, our method works even if several spin wave branches coexist in the investigated frequency interval, provided that the branches possess sufficiently different group velocities. We first measure the microwave scattering matrix of a network composed of distant antennas inductively coupled to the spin wave bath of the magnetic film. After a mathematical transformation to the time domain to get the transmission impulse response, the different spin wave branches are viewed as wave packets that reach successively the receiving antenna after different travel times. In analogy with time-of-flight spectroscopy, the wave packets are then separated by time gating. The time-gated responses are used to recalculate the contribution of each spin wave branch to the frequency domain scattering matrix. The dispersion relation of each branch stems from the absolute phase of the time-gated transmission parameter. The spin-wave wave vector can be determined unambiguously if the results for several propagation distances are combined, so as to get the dispersion relations.
1 February 2022 in Journal of Magnetism and Magnetic Materials