1 May 2021 in Composite Structures
18 April 2022 in Materials Science and Engineering: A
21 June 2023 in Composite Structures
PMPhilipp Christopher Morbitzer
Philipp Christopher Morbitzer
27 July 2022 in Thermochimica Acta
23 March 2023 in Applied Composite Materials
An interpenetrating metal-ceramic composite of AlSi10Mg and an open porous alumina foam, with residual porosity is investigated for the material damage under compressive load within an X-ray CT in-situ load stage. The focus of the research is on damage detection and evaluation with the commercial Avizo® software by ThermoFisher Scientific. Four different approaches are used to detect the material damage and compared afterward on their efficiency in detecting the material damage volume but not the porosity within the material. Image Stack Processing combined with different filtering techniques, as well as Digital Volume Correlation is used in this work to separate the material porosity and the material damage. For the here investigated material system with mainly spherical pores, a geometrical filter was very successful to separate porosity and damage. Nevertheless, the Digital Volume Correlation based approach showed many advantages in damage detection and turned out to be the approach of choice regarding damage onset.
13 February 2025 in The International Journal of Advanced Manufacturing Technology
In this study, the mechanical machinability of an interpenetrating metal-ceramic composite was investigated. The material was manufactured by gas pressure infiltration of a slurry-based ceramic preform and an AlSi10Mg cast alloy. The combination of a soft metal and a very hard ceramic brings many advantages in mechanical performance of the composite but challenges in the mechanical machining. Near net shape components manufactured and finished by mechanical processing is of interest. Therefore, diamond-grinding with different diamond grit tipped tools was investigated in a range of process parameters, such as the rotation speed, feed rate, and cutting depth. During the grinding process, the cutting forces were continuously measured, and the machined surface and tool quality were evaluated afterwards. Cold welding of the aluminum chips on the tool and the material surface were detected, and the effect of the superposition of ductile and brittle cutting mechanisms were observed. Increasing cutting forces and therefore increasing the process heat results in reclosing of brittle defects in Al2O3 by deformed aluminum. This effect leads to a reduced surface roughness when increasing the material removal rate by increasing cutting speed, feed rate, and cutting depth.