Luminescent coupling (LC) is a key phenomenon in monolithic tandem solar cells. This study presents a nondestructive technique to quantitatively evaluate the LC effect, addressing a gap in the existing predictions made by optical modeling. The method involves measuring the ratio of photons emitted from the high bandgap top cell that escape through the rear, contributing additional current to the bottom cell, and to those escaping from the front side of top cell. The findings indicate that in the analyzed monolithic perovskite/silicon tandem solar cells, more than 85% of the emitted photons escaping from the perovskite top cell are used to generate additional current in the bottom cell. This process notably reduces the mismatch in the generated current between each subcell, particularly when the current is limited by the low bandgap subcell. The presented method is applicable to a variety of monolithic tandem structures, providing vital information for subcell characterization, providing vital information for predicting energy output and optimization for outdoor applications.
21 May 2025 in Solar Energy Materials and Solar Cells
A controlled amount of excess lead iodide (PbI2) in the perovskite precursor has been widely used in perovskite solar cells (PSCs) to enhance the device's performance by passivating defects. However, an excessive amount of PbI2 can lead to significant hysteresis and reduced stability. Managing the excess PbI2 in the perovskite bulk and on the top (exposed) surface is achievable, but the bottom surface presents a challenge. This study offers a method for adjusting the amount of excess PbI2 in perovskite solar cells at both the bottom surface and the bulk of the perovskite layer. This treatment, known as buried interface modification, is effective for both negative-intrinsic-positive (n-i-p) and positive-intrinsic-negative (p-i-n) structures, achieving efficiencies of 25.9% and 24.6%, respectively, with negligible hysteresis and excellent stability of over 1000 hours under light at the maximum power point.
All-perovskite tandem solar modules offer the potential to achieve rapid increases in power conversion efficiency (PCE), yet efficient lead-tin (Pb-Sn) subcells often contain thermally unstable methylammonium (MA). Replacing MA with cesium (Cs) has been adopted to improve thermal stability but results in nonuniform nucleation and rapid crystallization, degrading large-area film quality. Here, we introduce p-π conjugated semicarbazide hydrochloride (SHCl) as a crystallization modifier in precursor solutions. The SH + and Cl − ions synergistically modulate the precipitation of Cs components and the growth process of perovskite films, achieving homogeneous nucleation and retarded crystal growth in formamidinium-cesium (FACs)–based Pb-Sn perovskites. Single-junction FACs Pb-Sn devices retained 85% of the initial efficiency after 700 hours at 85°C. The resultant all-perovskite tandem modules (20.25 square centimeters) achieved the certified PCE of 24.3%, representing the highest certified PCE among MA-free all-perovskite tandem modules. Encapsulated modules maintained 90 and 92% of their initial efficiency under ISOS-standardized damp heat (200 hours) and thermal cycling (200 cycles) tests, respectively.