19 July 2021 in IEEE Access
A design of high-gain Fabry-Perot cavity (FPC) antenna is presented with non-uniform frequency selective surface (FSS) superstrate and electromagnetic band gap (EBG) reflecting ground. The non-uniform FSS superstrate and EBG ground are utilized to flexibly control the attenuation constant $\alpha $ over a large antenna aperture while ensuring the resonance condition of the FPC. The uniformity of the amplitude of the aperture field is improved significantly while obtaining appropriate radiation efficiency. Therefore, the high gain and high aperture efficiency can be achieved within a desirable bandwidth. The theoretical gain estimation is conducted to prove the superiority of the proposed antenna over a referenced uniform one. A straight-forward design methodology is proposed based on the radial leaky-wave theory and the modified transverse equivalent network (TEN) model. The non-uniform high-gain FPC antenna with a diameter of $6.6\lambda _{0}$ is designed at the frequency of 15 GHz. Simulated results show that a gain of 24.6 dBi with an aperture efficiency of 67.9% has been achieved. The measured gain is 24.0 dBi with an aperture efficiency of 58.4%. The 10dB return loss bandwidth and 3 dB gain bandwidth are 5.3% and 3.2%, respectively. The proposed antenna overcomes the limit on aperture efficiency and gain of conventional uniform FPC antennas, and the presented methodology can guide the design of two-dimensional non-uniform high-gain FPC antennas.
3 October 2023 in IEEE Sensors Journal
This paper presents a high gain and low radar cross section (RCS) antenna with low profile for missile-borne sensing systems based on circularly polarized (CP) radial line slot array (RLSA). The RCS reduction of RLSA is studied for the first time by loading chessboard-arranged polarization conversion metasurface (PCM). Due to the dense and spiral arrangement of slots in RLSA, an integrated design of the radiating slot and periodic PCM unit is challenging. For RCS reduction at frequencies lower than the RLSA’s operating frequency, a PCM of high transmissivity is loaded onto the RLSA with an air gap. Wideband RCS reduction is achieved, while its influence on RLSA’s radiation performance is negligible. For RCS reduction at high frequencies, the PCM is directly attached on the RLSA to achieve a low profile for the entire antenna system. Under this arrangement, the mutual coupling between PCM units and RLSA’s radiating slots is much stronger leading to a degradation in RLSA’s radiation performance. Hence, a miniaturized PCM is employed to preserve the radiation performance while the coupling effect is analyzed and quantified into the array design. Two CP RLSA prototypes are fabricated and measured, with a diameter of 9.6λ 0 and profiles of 0.18λ 0 /0.60λ 0 at the center frequency of 10 GHz. The peak gain of these two RLSAs is 27.4 dBic and 27.6 dBic, respectively, which is reduced by 0.45 dB/0.27 dB compared with the RLSA without PCM. The bandwidth of at least 10 dB RCS reduction is from 13.2 GHz to 24.6 GHz for the high-frequency band and from 3.4 GHz to 7.4 GHz for the low-frequency band, respectively. Measured results are in good agreement with simulated ones.