Knowledge about capacity losses related to the solid electrolyte interphase (SEI) in sodium‐ion batteries (SIBs) is still limited. One major challenge in SIBs is that the solubility of SEI species in liquid electrolytes is comparatively higher than the corresponding species formed in Li‐ion batteries. This study sheds new light on the associated capacity losses due to initial SEI formation, SEI dissolution and subsequent SEI reformation, charge leakage via SEI and subsequent SEI growth, and diffusion‐controlled sodium trapping in electrode particles. By using a variety of electrochemical cycling protocols, synchrotron‐based X‐ray photoelectron spectroscopy (XPS), gas chromatography coupled with mass spectrometry (GC‐MS), and proton nuclear magnetic resonance (1H‐NMR) spectroscopy, capacity losses due to changes in the SEI layer during different open circuit pause times are investigated in nine different electrolyte solutions. It is shown that the amount of capacity lost depends on the interplay between the electrolyte chemistry and the thickness and stability of the SEI layer. The highest capacity loss is measured in NaPF6 in ethylene carboante mixed with diethylene carbonate electrolyte (i.e., 5 µAh h−1/2pause or 2.78 mAh g·h−1/2pause) while the lowest value is found in NaTFSI in ethylene carbonate mixed with dimethoxyethance electrolyte (i.e., 1.3 µAh h−1/2pause or 0.72 mAh g·h−1/2pause).
Electrolytes based on sodium bis(oxolato)borate (NaBOB) in organophosphates (trimethyl phosphate and triethyl phosphate (TEP)) have shown promise in sodium‐ion batteries when compared to conventional electrolytes in that they are fire resistant, fluorine‐free and are of lower toxicity. However, these electrolytes tend to exhibit low initial Coulombic efficiency and high overpotentials. We have here demonstrated that NaBOB in TEP can be used in cells with near‐commercial capacity loadings. Furthermore, we have shown that formation cycle conditions have a significant positive effect on the cell performance in these higher mass loading cells, and that modification of the formation cycle conditions can be used to increase the capacity retention, lower the overpotentials, and as such increase the rate capability. The viability of optimized formation protocols was also demonstrated in scaled up prototype cells.