16 October 2019 in Physical Review B
In this work an alternate pathway is demonstrated to form ultrathin cobalt ferrite () films by interdiffusion of /CoO bilayers. Bilayer samples with different /CoO thickness ratios have been prepared by reactive molecular beam epitaxy on Nb-doped (001) substrates to obtain cobalt ferrite films of varied stoichiometry. Subsequently, oxygen-assisted postdeposition annealing experiments for consecutive temperature steps between and have been conducted monitoring the interdiffusion process by means of high-resolution x-ray reflectivity, soft and angle-resolved hard x-ray photoelectron, and x-ray absorption spectroscopy. Magnetic properties were characterized using superconducting quantum interference device magnetometry. The interdiffusion process starts from annealing temperature and is completed for temperatures above . For completely interdiffused films with Co:Fe ratios larger than 0.84:2 a thin segregated CoO layer on top of the ferrite is formed. This CoO segregation is attributed to surface and interface effects. In addition, multiplet calculations of x-ray absorption spectra are performed to determine the occupancy of different sublattices. These results are correlated with the magnetic properties of the ferrite films. A stoichiometric film with partial inversion has been formed exhibiting homogeneously distributed and mainly valence states if the initial Co:Fe content is 1.09:2. Thus, for the formation of stoichiometric cobalt ferrite by the proposed postdeposition annealing technique an initial Co excess has to be provided as the formation of a top CoO layer is inevitable.
1 September 2018 in Photonics and Nanostructures - Fundamentals and Applications
3 June 2020 in Physical Review Materials
thin films with varying thickness were grown on by reactive molecular beam epitaxy. Soft and hard x-ray photoelectron spectroscopy measurements reveal a homogeneous cation distribution throughout the whole film with stoichiometric Ni:Fe ratios of 1:2 independent of the film thickness. Low energy electron diffraction and high resolution (grazing incidence) x-ray diffraction in addition to x-ray reflectivity experiments were conducted to obtain information of the film surface and bulk structure, respectively. For ultrathin films up to 7.3 nm, lateral tensile and vertical compressive strain is observed, contradicting an adaption at the interface of film and substrate lattice. The applied strain is accompanied by an increased lateral defect density, which is decaying for relaxed thicker films and attributed to the growth of lateral grains. Determination of cationic site occupancies in the inverse spinel structure by analysis of site sensitive diffraction peaks reveals low tetrahedral occupancies for thin, strained films, resulting in the partial presence of deficient rocksaltlike structures. These structures are assumed to be responsible for the enhanced magnetization of up to % of the bulk magnetization as observed by superconducting quantum interference device magnetometry for ultrathin films below 7.3 nm thickness.
6 July 2020 in Applied Physics Letters
O4 thin films with varying Ni amount (0 x 1.5) were deposited on MgO(001) via reactive molecular beam epitaxy. The growth process was monitored during film deposition by means of X-ray diffraction. All prepared films exhibit a well-ordered structure with complete vertical crystallinity throughout the whole film growth and flat surfaces of the final films independent of the Ni amount. An enhancement of the vertical compression in the initial growth continuously decreases up to a film thickness of 8 nm. During further growth, all films exhibit residual and constant vertical compression with lateral adaption of the final films to the substrate lattice, as observed by high energy surface X-ray diffraction experiments. Hard X-ray photoelectron spectroscopy measurements of the final films reveal increasing : ratios for higher Ni content and point to additional NiO agglomerations within the films exceeding the stoichiometric Ni amount of x = 1.