Bridget Renee Smith-Konter

Bridget Renee Smith-Konter

Auto-generated profile, based on publicly available information

Bridget Renee Smith-Konter

Department of Earth Sciences University of Hawaiʻi at Mānoa Honolulu HI USA

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 October 2020 in Science
Verified
Journal Article
Closed access
PDF file
XXXiaohua Xu
Xiaohua Xu
DSDavid T. Sandwell
David T. Sandwell
LWLauren A. Ward
Lauren A. Ward
CMChris W. D. Milliner
Chris W. D. Milliner
BSBridget R. Smith-Konter
Bridget R. Smith-Konter
YBYehuda Bock
Yehuda Bock
Mapping out backward motion: Most deformation associated with an earthquake is, not surprisingly, in the same direction as the fault rupture. Xu et al. used satellite imaging to find areas of deformation associated with the 2019 Ridgecrest earthquake sequence that moved in the opposite direction. These regions moved in this direction because of inelastic deformation, which helped to accommodate the overall fault rupture for the sequence. The observations were possible because of improved radar imaging and are likely more common than previously believed. Science , this issue p. 605

2 October 2018 in Geophysical Research Letters
Verified
Journal Article
Open access
PDF file
XXXiaohua Xu
Xiaohua Xu
LWLauren A. Ward
Lauren A. Ward
JJJunle Jiang
Junle Jiang
BSBridget Smith‐Konter
Bridget Smith‐Konter
ETEkaterina Tymofyeyeva
Ekaterina Tymofyeyeva
DSDavid T. Sandwell
David T. Sandwell
A major challenge for understanding the physics of shallow fault creep has been to observe and model the long‐term effect of stress changes on creep rate. Here we investigate the surface creep along the southern San Andreas fault (SSAF) using data from interferometric synthetic aperture radar spanning over 25 years (ERS 1992–1999, ENVISAT 2003–2010, and Sentinel‐1 2014–present). The main result of this analysis is that the average surface creep rate increased after the Landers event and then decreased by a factor of 2–7 over the past few decades. We consider quasi‐static and dynamic Coulomb stress changes on the SSAF due to these three major events. From our analysis, the elevated creep rates after the Landers can only be explained by static stress changes, indicating that even in the presence of dynamically triggered creep, static stress changes may have a long‐lasting effect on SSAF creep rates.

1 January 2022 in Icarus
Verified
Journal Article
Closed access
LBLiliane M.L. Burkhard
Liliane M.L. Burkhard
BSBridget R. Smith-Konter
Bridget R. Smith-Konter
SFSarah A. Fagents
Sarah A. Fagents
MCMarissa E. Cameron
Marissa E. Cameron
GCGeoffrey C. Collins
Geoffrey C. Collins
RPRobert T. Pappalardo
Robert T. Pappalardo

24 June 2022 in Journal of Geophysical Research: Solid Earth
Verified
Journal Article
Closed access
LWLauren A. Ward
Lauren A. Ward
KGKatherine A. Guns
Katherine A. Guns
BSBridget R. Smith‐Konter
Bridget R. Smith‐Konter
XXXiaohua Xu
Xiaohua Xu
YBYehuda Bock
Yehuda Bock
DSDavid T. Sandwell
David T. Sandwell

30 July 2015 in Geophysical Journal International
Verified
Journal Article
Open access
PDF file
XTXiaopeng Tong
Xiaopeng Tong
DSDavid T. Sandwell
David T. Sandwell
BSBridget Smith-Konter
Bridget Smith-Konter
Moment accumulation rate (also referred to as moment deficit rate) is a fundamental quantity for evaluating seismic hazard. The conventional approach for evaluating moment accumulation rate of creeping faults is to invert for the slip distribution from geodetic measurements, although even with perfect data these slip-rate inversions are non-unique. In this study, we show that the slip-rate versus depth inversion is not needed because moment accumulation rate can be estimated directly from surface geodetic data. We propose an integral approach that uses dense geodetic observations from Interferometric Synthetic Aperture Radar (InSAR) and the Global Positioning System (GPS) to constrain the moment accumulation rate. The moment accumulation rate is related to the integral of the product of the along-strike velocity and the distance from the fault. We demonstrate our methods by studying the Creeping Section of the San Andreas fault observed by GPS and radar interferometry onboard the ERS and ALOS satellites. Along-strike variation of the moment accumulation rate is derived in order to investigate the degree of partial locking of the Creeping Section. The central Creeping Segment has a moment accumulation rate of 0.25–3.1 × 1015 Nm yr−1 km−1. The upper and lower bounds of the moment accumulation rates are derived based on the statistics of the noise. Our best-fitting model indicates that the central portion of the Creeping Section is accumulating seismic moment at rates that are about 5 per cent to 23 per cent of the fully locked Carrizo segment that will eventually be released seismically. A cumulative moment budget calculation with the historical earthquake catalogue (M > 5.5) since 1857 shows that the net moment deficit at present is equivalent to a Mw 6.3 earthquake.

12 April 2021 in Journal of Geophysical Research: Solid Earth
Verified
Journal Article
Open access
PDF file
LWLauren A. Ward
Lauren A. Ward
BSBridget R. Smith‐Konter
Bridget R. Smith‐Konter
XXXiaohua Xu
Xiaohua Xu
DSDavid T. Sandwell
David T. Sandwell
Rheologic variations in the Earth's crust (like elastic plate thickness [EPT] or crustal rigidity) modulate the rate at which seismic moment accumulates for potentially hazardous faults of the San Andreas Fault System (SAFS). To quantify rates of seismic moment accumulation, Global Navigation Satellite Systems, and Interferometric Synthetic Aperture Radar data were used to constrain surface deformation rates of a four‐dimensional viscoelastic deformation model that incorporates rheological variations spanning a 900 km section of the SAFS. Lateral variations in EPT, estimated from surface heat flow and seismic depth to the lithosphere‐asthenosphere boundary, were converted to lateral variations in rigidity and then used to solve for seismic moment accumulation rates on 32 fault segments. We find a cluster of elevated seismic moment rates (11–20 × 1015 Nm year−1 km−1) along the main SAFS trace spanning the historical Mw 7.9 1857 Fort Tejon earthquake rupture length; present‐day seismic moment magnitude on these segments ranges from Mw 7.2–7.6. We also find that the average plate thickness in the Salton Trough is reduced to only 60% of the regional average, which results in a ∼60% decrease in moment accumulation rate along the Imperial fault. Likewise, a 30% increase of average plate thickness results in at least a ∼30% increase in moment rate and even larger increases are identified in regions of complex plate heterogeneity. These results emphasize the importance of considering rheological variations when estimating seismic hazard, suggesting that meaningful changes in seismic moment accumulation are revealed when considering spatial variations in crustal rheology.