9 August 2015 in Geophysical Research Letters
Interferometric synthetic aperture radar (InSAR) is a key tool for the analysis of displacement and stress changes caused by large crustal earthquakes, particularly in remote areas. A challenge for traditional InSAR has been its limited spatial and temporal coverage especially for very large events, whose dimensions exceed the typical swath width of 70–100 km. This problem is addressed by the ALOS‐2 satellite, whose PALSAR‐2 instrument operates in ScanSAR mode, enabling a repeat time of 2 weeks and a swath width of 350 km. Here we present InSAR line‐of‐sight displacement data from ALOS‐2/PALSAR‐2 observations covering the Mw 7.8 Gorkha, Nepal earthquake and its Mw 7.3 aftershock that were acquired within 1 week of each event. The data are made freely available and we encourage their use in models of the fault slip and associated stress changes. The Mw 7.3 aftershock not only extended the rupture area of the main shock toward the east but also left a 20 km gap where the fault has little or no coseismic slip. We estimate this unslipped fault patch has the potential to generate a Mw 6.9 event.
4 February 2016 in Geophysical Journal International
CMChristopher W.D. Milliner
Christopher W.D. Milliner
+2
Geodetic slip inversions for three major (Mw > 7) strike-slip earthquakes (1992 Landers, 1999 Hector Mine and 2010 El Mayor–Cucapah) show a 15–60 per cent reduction in slip near the surface (depth < 2 km) relative to the slip at deeper depths (4–6 km). This significant difference between surface coseismic slip and slip at depth has been termed the shallow slip deficit (SSD). The large magnitude of this deficit has been an enigma since it cannot be explained by shallow creep during the interseismic period or by triggered slip from nearby earthquakes. One potential explanation for the SSD is that the previous geodetic inversions lack data coverage close to surface rupture such that the shallow portions of the slip models are poorly resolved and generally underestimated. In this study, we improve the static coseismic slip inversion for these three earthquakes, especially at shallow depths, by: (1) including data capturing the near-fault deformation from optical imagery and SAR azimuth offsets; (2) refining the interferometric synthetic aperture radar processing with non-boxcar phase filtering, model-dependent range corrections, more complete phase unwrapping by SNAPHU (Statistical Non-linear Approach for Phase Unwrapping) assuming a maximum discontinuity and an on-fault correlation mask; (3) using more detailed, geologically constrained fault geometries and (4) incorporating additional campaign global positioning system (GPS) data. The refined slip models result in much smaller SSDs of 3–19 per cent. We suspect that the remaining minor SSD for these earthquakes likely reflects a combination of our elastic model's inability to fully account for near-surface deformation, which will render our estimates of shallow slip minima, and potentially small amounts of interseismic fault creep or triggered slip, which could ‘make up’ a small percentages of the coseismic SSD during the interseismic period. Our results indicate that it is imperative that slip inversions include accurate measurements of near-fault surface deformation to reliably constrain spatial patterns of slip during major strike-slip earthquakes.
5 June 2017 in IEEE Transactions on Geoscience and Remote Sensing
AGAlejandro Gonzalez-Ortega
Alejandro Gonzalez-Ortega
The Cerro Prieto geothermal field (CPGF) lies at the step-over between the imperial and the Cerro Prieto faults in northern Baja California, Mexico. While tectonically this is the most active section of the southern San Andreas Fault system, the spatial and temporal deformation in the area is poorly resolved by the sparse global positioning system (GPS) network coverage. Moreover, interferograms from satellite observations spanning more than a few months are decorrelated due to the extensive agricultural activity in this region. Here we investigate the use of frequent, short temporal baseline interferograms offered by the new Sentinel-1A satellite to recover two components of deformation time series across these faults. Following previous studies, we developed a purely geometric approach for image alignment that achieves better than 1/200 pixel alignment needed for accurate phase recovery. We construct interferometric synthetic aperture radar time series using a coherence-based small baseline subset method with atmospheric corrections by means of common-point stacking. We did not apply enhanced spectral diversity because the burst discontinuities are generally small (<1.4 mm) and can be effectively captured during the atmospheric corrections. With these algorithms, the subsidence at CPGF is clearly resolved. The maximum subsidence rate of 160 mm/yr, due to extraction of geothermal fluids and heat, dominates the ~40 mm/yr deformation across the proximal ends of the imperial, the Cerro Prieto, and the indiviso faults.
15 January 2020 in Seismological Research Letters
Interferometric Synthetic Aperture Radar is an important tool for imaging surface deformation from large continental earthquakes. Here, we present maps of coseismic displacement and strain from the 2019 Ridgecrest earthquakes using multiple Sentinel‐1 images. We provide three types of interferometric products. (1) Standard interferograms from two look directions provide an overview of the deformation and can be used for modeling coseismic slip. (2) Phase gradient maps from stacks of coseismic interferograms provide high‐resolution () images of strain concentration and surface fracturing that can be used to guide field surveys. (3) High‐pass filtered, stacked, unwrapped phase is decomposed into east–west and up–down, south–north components and is used to determine the sense of fault slip. The resulting phase gradient maps reveal over 300 surface fractures, including triggered slip on the Garlock fault. The east–west component of high‐pass filtered phase reveals the polarity of the strike‐slip offset (right lateral or left lateral) for many of the fractures. We find a small number of fractures that have slip polarity that is retrograde to the background tectonic stress. This is similar to observations of retrograde slip observed near the 1999 7.1 Hector Mine rupture, but the Ridgecrest observations are more completely imaged by the frequent and high‐quality acquisitions from the twin Sentinel‐1 spacecrafts. Determining whether the retrograde features are triggered slip on existing faults, or compliant fault deformation in response to stress changes from the Ridgecrest earthquakes, or new Coulomb‐style failures, will require additional field work, modeling, and analysis.
10 February 2020 in Geophysical Research Letters
The 4 July 2019 Mw6.4 and subsequent 6 July 2019 Mw7.1 Ridgecrest sequence earthquakes (CA, USA) ruptured orthogonal fault planes in a low slip rate (1 mm/year) dextral fault zone in the area linking the Eastern California Shear Zone and Walker Lane. This region accommodates nearly one fourth of plate boundary motion and has been proposed to be an incipient transform fault system that could eventually become the main tectonic boundary, replacing the San Andreas Fault. We investigate the rupture process of these events using a novel simultaneous kinematic slip method with joint inversion of high‐rate GNSS, strong motion, GNSS static offset, and Interferometric Synthetic Aperture Radar data. We model the Coulomb stress change to evaluate how the Mw6.4 earthquake may have affected the subsequent Mw7.1 event. Our findings suggest complex interactions between several fault structures, including dynamic and static triggering, and provide important context for regional seismic source characterization and hazard models.
30 October 2020 in Science
Mapping out backward motion: Most deformation associated with an earthquake is, not surprisingly, in the same direction as the fault rupture. Xu et al. used satellite imaging to find areas of deformation associated with the 2019 Ridgecrest earthquake sequence that moved in the opposite direction. These regions moved in this direction because of inelastic deformation, which helped to accommodate the overall fault rupture for the sequence. The observations were possible because of improved radar imaging and are likely more common than previously believed. Science , this issue p. 605