1 April 2001 in Journal of Hydraulic Research
Flow characteristics in an open channel with a constriction are investigated numerically by using a three-dimensional multi-level hydrodynamic model. In this model, the two-step Euler predictor-corrector algorithm is introduced to predict and correct free surface water level. The momentum equations in horizontal directions are discretized in an explicit scheme for the component velocities u and v, and the continuity equation is discretized for the velocity w in an implicit scheme in uniform and non-uniform grid systems. The model has been tested against analytical solutions for two standard cases and used to study sudden contraction and expansion open channel flow. The numerical results are in good agreement with analytical and experimental data. Simulated flow patterns for the sudden contraction and expansion flow show reasonable flow characteristics downstream of an opening.
1 November 2021 in Physics of Fluids
In this paper, we introduce a reduced order model (ROM) for the propagation of nonlinear multi-directional ocean wave-fields. The ROM relies on Galerkin projection of Zakharov equations embedded in the high-order spectral (HOS) method, which describes the evolution of nonlinear waves. The dominant flow features of wave evolution are computed from proper orthogonal decomposition (POD) and these modes are used for the projection. The HOS scheme to compute the vertical velocity is treated in a novel way for an efficient implementation of POD-based ROM. We refer to this alternative formalism of HOS as HOS-simple. The final reduced order model (ROM) is derived from the Galerkin projection of HOS-simple. For the case of irregular waves, where the number of modes required are in the range of 200, the ROM has no significant advantage since both HOS and HOS-simple are much faster than real-time. The real advantage is demonstrated in multi-directional (or short-crested) irregular waves, where the ROM is the only model capable of achieving real-time computation, a major improvement to the standard HOS method. The potential use of the ROM in propagating short-crested waves from far-field to near-field for real-world applications involving wave probes in a wave tank/controlled environment as well as X-band radar in open ocean is also demonstrated.
1 July 1995 in Journal of Waterway, Port, Coastal, and Ocean Engineering
An experimental study of plunging-wave impacts on flat vertical walls suspended just above the still water level has been presented. Simultaneous pressure measurements are examined in conjunction with video records. From the results, impact conditions have been found to vary from one associated with a rising water mass and a progressively steeper wavefront during wave action to one with a well-developed plunging jet and significant air entrapment at impact. Pressure distributions and impact force time histories have also been presented to elucidate the spatial and temporal variations of the impact loads. For the plunging wave examined in the study, the highest horizontal force is found to be about two times higher than that on a surface-piercing wall over the zone above still water level. Dominant force oscillations immediately after the occurrence of peak force have also been found. Such oscillations, with amplitudes as high as nonimpact force levels, can have significant influence on the dynamics and st...
1 May 2024 in Physics of Fluids
A systematic approach incorporating precision-controlled experiments and high-fidelity numerical simulations has been employed to delve deeper into the physics of extreme wave impact pressures. Using a suite of high-speed imaging and high-resolution pressure sensing techniques that are accurately synchronized with the wave generation, a consistent and well-correlated set of data providing details of the focusing incident wave front, flow velocities, and impact pressure time histories has been successfully obtained. The numerical simulations using a validated incompressible smoothed particle hydrodynamics (ISPH) provided further details that were not tractable in the experiments. Based on the results obtained, there were five broad impact scenarios identified, ranging from focusing crest impacts to plunging jet impacts with varying entrapped air. Among these impact types, the highest impact pressures were those associated with a focusing wave crest. It has been found that high impact pressures were correlated with a convergence of the horizontally impinging overturning crest and the vertical surge of the wall boundary water mass, but with the overturning crest impingement just ahead of the arrival of the wall boundary water mass, which in essence amounted to the impingement of a focusing wave front. Depending on the relative arrival times of the impinging crest and the wall boundary upsurge, the impact scenarios could vary from an up-slosh to a jet impingement with a clear entrapped air pocket, followed by a flip-through of the incident crest. For the scenario with the highest impact pressures, broadly classified as type II impact in this paper, the peak pressures could reach as high as 85ρC2, an order of magnitude higher than impact scenarios without the focusing effect, such as the scenario with a plunging jet impact with entrapped air (classified as types III and IV impact in this study). As the volume of entrapped air for this scenario was relatively small, the one-phase ISPH model used in this study was able to capture the peak pressure characteristics, including the peak pressure amplitudes. However, in scenarios with significantly highly entrapped air during impact, a two-phase model would be necessary.