In this paper, we propose a new capacitor degradation evaluation method aimed at failure prediction and suitable for digitally controlled switching mode power supply (SMPS) for servers. Electrolytic capacitors have one of the highest component failure rates in SMPS; therefore, we attempt to detect an equivalent series resistance degradation of the electrolytic capacitor directly from the data fetched to a digital controller of the SMPS. With a SPICE simulation and a rapid control prototyping evaluation, we confirm the degradation can be detected by the data at a transient response under a normal operation without additional circuits. Even only 10% of a load step change, which commonly occurs in SMPS for servers, causes detectable transient response degradation.
1 December 1991 in Japanese Journal of Applied Physics
Thin-film S/N heterostructures of superconducting BiSrCaCuO and metallic BiSrCuO with good surface morphology, crystallinity, and superconducting properties were formed on (100) MgO substrates by halide chemical vapor deposition (CVD). Critical temperatures (Tc at zero resistance) and critical current densities (Jc) of the BiSrCaCuO films on MgO substrate were Tc=75 to 80 K and Jc=1×106 A/cm2 at 60 K. Resistivity of the metallic BiSrCuO films was 0.7 to 1.5×10-3 Ω·cm from 10 to 300 K. High-resolution transmission electron microscopy (HRTEM) images showed the interface between the BiSrCaCuO and BiSrCuO films to be atomically abrupt. The critical temperature of S/N multilayer samples was about 75 K.
We have developed GdxY1-xCa4O(BO3)3 (GdYCOB) crystal noncritically phase matchable for third-harmonic generation of a 1064 nm light by type-I mixing (1064 + 532 → 355 nm). However, during high-power operation, degradation of output power and distortion of beam pattern occurred due to photo-induced damages and thermal dephasing. In this paper, we report on nonlinear optical properties and improved the performance of GdYCOB by circumvention of photo-induced damages and thermal dephasing.