Carbon Capture, Utilization, and Storage (CCUS) technology has emerged as the bottom-line technology for achieving carbon neutrality goals in China. The development of Carbon Dioxide Enhanced Oil Recovery (CO2-EOR) not only increases revenue for high-investment CCUS projects but also enables permanent CO2storage in the oil reservoir. However, the basin is used as the research object to evaluate the CO2storage potential of the oil reservoir. The evaluation results are inaccurate and unable to support the implementation of later CCUS projects. Here, more accurate oil reservoir data is employed as the evaluation object. It is the first time at the national level to screen oil reservoirs to distinguish between CO2miscible and immiscible, and evaluate the potential of CO2-EOR and CO2storage in the reservoir. The research results show a total of 2570 suitable oil reservoirs in 4386 candidate oil reservoirs nationwide. About 1.26 billion tons of additional crude oil can be produced by CO2-EOR technology. This includes approximately 580 million tons of additional oil from CO2miscible flooding and 680 million tons from CO2immiscible flooding. The study further refines the CO2geological utilization data and provides a theoretical basis for CCUS project site selection in China.
Domain reversal in LiTaO3 with period 6.5 mu m and 1:3 duty cycle has been obtained by using a partially switching technique in a 0.25 mm thick sample. A CW second-order quasi-phase-matched second-harmonic-generation experiment yielded a 12 mu W, 407 nm blue light output for 200 mW, 814 nm fundamental input. The technique can be used for the fabrication of the periodic poled LiTaO3 for bulk violet and ultraviolet second-harmonic generation and for the fabrication of other ferroelectric microstructure materials.
Modern application trends for the development of RGB displays with a high color rendering index (CRI) require light-emitting diode (LED) display technology with greater miniaturization and efficient LEDs operating at deep red wavelengths greater than 650 nm. Although InGaN-based LEDs have achieved high miniaturization performance, efforts to obtain deep-red emission by increasing the indium content introduce a number of factors limiting optical performance, such as high in-plane stress, high dislocation densities, and phase separation. The present work addresses this issue by fabricating deep-red emitting InGaN-based LEDs on an underlying GaN template layer grown from hexagonal GaN column structures formed on a porous SiNx masking layer and coalesced in situ as an underlying layer with significantly reduced internal stresses and dislocation densities. As a result, the fabricated miniature LEDs obtain an external quantum efficiency of 9.1% and a peak wavelength of 672 nm at a current density of 0.4 A/cm2. Accordingly, this work confirms the potential for fabricating InGaN-based LEDs to achieve high-CRI mini/micro RGB displays.
Low-voltage tunnel junctions (TJs) are essential for vertically integrated III-nitride emitters, yet their voltage penalty limits monolithic multicolor integration. We report a GaN-based TJ in which a 5 nm InGaN sacrificial interlayer is thermally reconstructed during a subsequent in-reactor step, producing a laterally redistributed In-rich tunneling interface. Four metalorganic chemical vapor deposition (MOCVD)-grown blue LED samples are compared: a p+-GaN/n+-GaN homojunction (LED A), the same homojunction after a 1000 °C, 3 min treatment (LED A-HT), a TJ with an intact 5 nm n-In0.3Ga0.7N interlayer (LED B), and its reconstructed counterpart (LED C). Cross-sectional TEM and In elemental mapping show a continuous interlayer in TJ B, whereas TJ C contains laterally redistributed In-rich regions and nanoscale void-like structural features; the blue InGaN/GaN quantum wells remain clearly resolved after the thermal process. LED C exhibits a device turn-on voltage of 3.4 V, compared with 4.1 V for LED B and 4.6 V for LED A; LED A-HT shows no comparable reduction. Similar peak wavelengths and linewidths among the four LEDs show that the blue test active region retains its peak position and spectral width after the different TJ treatments. Incorporation of the reconstructed TJ into a monolithic InGaN blue/green/red stack yields selectively driven three-color electroluminescence, wafer-scale PL peak-wavelength standard deviations below 3 nm, and an experimental CIE 1931 triangle area equal to 72.9% of the BT.2020 triangle area at the stated operating points. These results provide an MOCVD-compatible approach to reducing the voltage penalty of buried nitride TJs in vertically integrated emitters.
18 November 2025 in IEEE Transactions on Electron Devices
The poor efficiency of currently existing InGaN-based red light-emitting diodes (LEDs) is the primary factor limiting the advancement of full-color, high-resolution mini-/micro-LED displays. However, while the application of square tile-patterned GaN templates formed on sapphire substrates has been demonstrated to improve the emission performance of InGaN-based red LEDs, the impact of template size remains poorly understood. This work addresses this issue by preparing square tile-patterned GaN templates with varying tile dimensions of $500\times 500~\mu $ m to $200\times 200~\mu $ m. The impact of template size on the relaxation state, dislocation density, and surface morphology of the GaN template layers is analyzed systematically, and the emission properties of InGaN-based red mini-LED chips fabricated on these GaN templates are characterized in detail. Experimental results indicate that an optimal template size of $300\times 300~\mu $ m not only promotes lateral relaxation of the underlying layers and mitigates the quantum-confined Stark effect (QCSE), but also enhances crystal quality and reduces dislocation density. Consequently, the LEDs fabricated on this template exhibit higher emission intensity and improved wavelength stability compared to conventional InGaN-based red LEDs grown on planar GaN substrates. A red mini-LED fabricated using the optimal template demonstrates a peak emission wavelength of 634.0 nm at 1 A/cm2, with a 57% increase in peak external quantum efficiency (EQE) compared to the LED grown on the unpatterned template.