An overview of laser welding methods and additive manufacturing technologies used in modern mechanical engineering is given, and the main trends and aspects of these technologies are discussed. Laser welding processes of thermally hardened aluminum alloys and problems of obtaining high-strength welded joints are considered. The additive growth of heterogeneous materials is analyzed taking into account the dimensionless parameters determining the structure of materials fabricated by additive manufacturing.
1 March 2020 in Journal of Applied Mechanics and Technical Physics
This paper describes the experimental study of strength characteristics and the microstructure of a permanent joint of dissimilar materials (VT20 titanium alloy and V-1461 aluminum alloy), obtained by laser butt welding. Optical and electron microscopy, X-ray spectral and phase analysis, and the transmission diffraction method with the help of synchrotron radiation are all used to investigate the properties of a weld. It is shown that the laser radiation offset relative to the contact surface of dissimilar materials significantly changes the microstructure and phase composition of the intermetallic interlayer formed between the materials welded, thereby affecting the strength of dissimilar welded joints.
1 September 2021 in Journal of Applied Mechanics and Technical Physics
Results of an experimental study of the strength characteristics and structural-phase composition of a nondetachable connection of dissimilar materials based on thermally hardened aluminum alloys D16T of the Al-4.4Cu-1.5Mg system and 1420 of the Al-5.2Mg-2.1Li system obtained by butt-end laser welding are reported. The phase composition of the welded joint is studied with the use of synchrotron radiation by the method of transmission diffraction. The welded joint microstructure is considered by optical microscopy. It is demonstrated that heat treatment (quenching and artificial aging) allows one to improve the chemical properties of the welded joint.