Introducing carbonyl nickel’s fine particles into a thermo-resistant polyamide phenylone can significantly improve thermo-physical characteristics of the CM and extend the operational temperature range of products made from these materials. Introducing carbonyl nickel in the amount of 5 – 20 mass %, thermo-resistance of phenylon C-1 increases by 10-30 degrees (most significantly in the case of a 20 % content), thermal conductivity grows by 38 %, and temperature conductivity of composite materials ranges from 1.75∙10-4 to 1.9∙10-4, which is 1.3 - 1.4 times as high as that of the initial phenylon.
22 August 2019 in Eastern-European Journal of Enterprise Technologies
The article presents the results of scientific research on the processes of operation of graphite plastic in a tribological unit. The effect of sliding speed and load on the intensity of wear and coefficient of friction of graphite plastic was determined, and mathematical models describing the tribotechnical behavior of graphite plastic depending on the load and sliding speed of the friction unit were developed. The research carried out in the paper made it possible to reveal the influence of the technological parameters of the operation process on the intensity of linear wear and the coefficient of friction of graphite plastic. The obtained mathematical dependencies make it possible to reliably predict the duration of the developed graphite plastic in tribological units of modern technology, which is important for ensuring the efficiency and reliability of machines and mechanisms.
The article presents the results of a comprehensive experimental and theoretical study of the tribotechnical characteristics of a composite material based on polytetrafluoroethylene reinforced with polyimide fiber. The main objective of the study was to determine the quantitative regularities governing changes in the intensity of linear wear as a function of external tribological loading parameters, as well as to establish optimal operating modes for the material. A mathematical modeling approach based on a full factorial design was employed to plan and conduct the experiments. The experimental results enabled the derivation of a first-order regression equation describing the dependence of wear on the variable parameters. Statistical analysis of the model included an assessment of its adequacy and the significance of the regression coefficients. By constructing response surfaces, zones of minimum wear intensity were identified, and optimal operating conditions for the material under dry friction were determined. The study confirms the significant influence of both individual factors and their interaction on the wear resistance of the composite material. It was established that deviations of tribological loading parameters from their optimal values lead to a substantial increase in linear wear intensity. The proposed approach can be effectively applied to optimize the operating modes of composite materials based on polytetrafluoroethylene and polyimide fiber in friction units of machines and mechanisms operating under high loads and requiring enhanced wear resistance.