The running safety and passenger comfort levels in a vehicle are tightly related to the technical state of the suspension elements. The technical state of the suspension depends of the service life time as its components become old and wear out. In this paper, a study on the dynamic behaviour of a railway vehicle is established in relation to the damping elements in one of its suspension stages. An experimental measurement model is developed, obtaining a set of useful signals for the identification of the dynamic parameters of the vehicle and developing a test through the application of the operational modal analysis technique, using least-squares complex exponential method as a basis to validate the numerical model of the multi-body system. Then, the study focuses on developing numerical simulations for the identification of the technical state of the dampers by the registration of dynamic variables under commercial service conditions and on estimating the state of the suspension elements.
The present work poses a method for the measurement of geometric parameters of rail wheels in a dynamic condition, by reconstructing the profilogram from a portion of the wheel surface wear with artificial vision. The suggested procedure can work with a two-dimensional laser displacement transducer or by processing a sole image from a single camera with a structured light source. These two procedures require fewer devices and simpler implementation processes and allow the use of mathematical algorithms that demand less information processing, thus generating more accurate results. Railway operators may implement this method to perform predictive maintenance to their rolling stock at a fraction of the regular cost; thus achieving better precision, availability, maintenance performance and improving safety. Results were compared to those given by commercial equipment, showing similar precision but a better cost–benefit relation.
22 November 2016 in International Journal on Interactive Design and Manufacturing (IJIDeM)
Many structural elements are exposed to load conditions that are difficult to model during the design phase, such as environmental uncertainties, random impacts, and overloading, amongst others, thus increasing unprogrammed maintenance and reducing confidence in the reliability of the structure in question. One way to deal with this problem is to monitor the structural condition of the element. This approach requires supervising several signals coming from critical locations and then performing an accurate condition estimation of the element in question based on the data collected. This study implements a method to diagnose and evaluate the reliability of the bolster beam structure of the railway vehicle during a fatigue test. The results show that multidimensional monitoring not only diagnoses the element accurately but also results in correct estimation of reliability.
1 January 2013 in International Journal of Vehicle Safety
On-board diagnostics of technical condition of the brake system elements provide control during the inter-control period of operation. The use of ABS requires further development of on-board diagnostic tools based on the development of new diagnostic methods using multilevel structural and effect schemes, primarily in terms of efficiency parameters. Increase of the information content by increasing the number of measured kinematic parameters and improving the algorithms for generating control signals for the brake system actuators showed effectiveness of diagnostics. To implement diagnostics of technical state of the brake system elements on board of a vehicle, a structural diagram of a diagnostic device, which uses telecommunication means of connection with an expert system and a voltage strain gauge in the coupling device of a truck has been proposed. It is advisable to carry out in-depth element-by-element diagnostics under bench conditions, with the maximum possible exclusion of random factors affecting the process. To summarize all information about the state of the vehicle's braking system, it is necessary to use an expert system.