20 July 2021 in ACS Applied Energy Materials
We describe a general approach for protecting metal halide perovskite solar cells against degradation in high-humidity environments using a sputtered barrier coating. A SiO2 protective layer, applied to two different types of perovskite solar cells, was deposited without strongly impacting the initial device performance. The degradation of the cells was imaged in real time using laser beam-induced current (LBIC) measurements in an accelerated test. We show that SiO2 barrier films can improve the tolerance of the devices to extreme humidity conditions and extend lifetimes by a factor of ∼60 when a 45 nm SiO2 barrier layer is applied to CH3NH3PbI3 and by a factor of ∼600 when a 300 nm barrier is applied to a triple-cation perovskite material. The LBIC data revealed that the approach promises protection against degradation initiation at the edges of scribed lines, which will be necessary for the fabrication of monolithically integrated modules.
7 June 2019 in Sustainable Energy & Fuels
We calculated the energy yields of perovskite/CIGS tandems for real world irradiance and temperature variations.
25 April 2022 in Sustainable Energy & Fuels
The calculated levelized cost of electricity for single junction and tandem devices show that when the time for perovskite devices to degrade to 85% of the original output (T85) is only 3 years, tandem device are economically favorable.
13 June 2018 in IEEE Journal of Photovoltaics
The presence of a Te-rich surface or an elemental Te layer is beneficial for the formation of a low-barrier back contact for high-efficiency CdTe solar cells. Etching processes are widely used to form Te-rich CdTe surfaces, while deposition processes such as evaporation are used to form elemental Te layers. Here, we show that a reaction between methylammonium iodide (CH$_3$NH$_3$I, MAI) and CdTe can be used to simply and controllably produce elemental Te over a wide processing window. Both X-ray diffraction and Raman spectroscopy confirmed the formation of a Te layer. The MAI-produced Te layer reduces the Schottky barrier height, improves the open-circuit voltage (V$_\text{OC}$) and fill factor, and outperforms contacts formed with the evaporated Te. We examined the effect of MAI reaction temperature and the amount of Cu needed to optimize the device. CdS/CdTe stacks that were treated with a 125 mM MAI solution and heated to 125 °C for 10 min showed the best power conversion efficiency (PCE) of 14.1%, while the best efficiency of a standard device without treatment was 13.0%, and the best PCE of an evaporated Te layer was 13.8%. Notably, the improved efficiency for the MAI-treated devices was achieved with less Cu than was required for the standard device. With an indium tin oxide back electrode, the PCE was also improved from 11.0% to 12.2% with MAI treatment, providing a potential route for fabricating high-efficiency transparent or bifacial CdTe solar cells.
1 June 2021 in Solar Energy Materials and Solar Cells
1 October 2020 in Cell Reports Physical Science