An overview of the state of art in ferroelectric thin films is presented. First, we review applications: microsystems’ applications, applications in high frequency electronics, and memories based on ferroelectric materials. The second section deals with materials, structure (domains, in particular), and size effects. Properties of thin films that are important for applications are then addressed: polarization reversal and properties related to the reliability of ferroelectric memories, piezoelectric nonlinearity of ferroelectric films which is relevant to microsystems’ applications, and permittivity and loss in ferroelectric films—important in all applications and essential in high frequency devices. In the context of properties we also discuss nanoscale probing of ferroelectrics. Finally, we comment on two important emerging topics: multiferroic materials and ferroelectric one-dimensional nanostructures.
-type conductivity has been observed in (CCTO) ceramics and also in thin films deposited by pulsed laser deposition. and relationships of the CCTO thin films showed characteristics typical of a tunnel metal-insulator-semiconductor structure, evidencing its capacitance response as the origin of the high apparent dielectric constant observed in CCTO thin films. The very thin insulating layer on top of the film can be reduced in thickness by treatment in HCl acid, as shown by smaller threshold voltages in the curves. The overall behavior is compatible with a conduction activation energy of in the bulk of the film, and a diffusion potential at the interface of . The acceptor concentration is of the order of .
Direct current (dc) bias-induced acoustic resonance phenomena have been observed in micromachined tunable thin-film capacitors based on paraelectric thin films. Both resonance and antiresonance frequencies are dc bias dependent. The antiresonance frequency is only weakly dc bias dependent and shifts slightly down with increasing dc bias. The resonance frequency shows a much stronger dependence on the applied dc bias than the antiresonance frequency, and also shifts down to lower frequencies with increasing bias. The resonance frequency shifted by for a frequency of about 3 GHz and an applied field of 730 KV/cm. At the same time the effective electromechanical coupling constant increased up to . The tuning of the resonance frequency depends on the tunability of the film permittivity and on the mechanical load on the piezoactive layer. The constitutive equations controlling the tuning of the resonance and antiresonance frequency were derived from the Landau theory using the -expansion of its free energies. The theoretical predictions show that, in the considered system, the frequency of the first-order resonance ( resonance) will always shift down with increasing bias, whereas the antiresonance frequency might shift up or down with increasing bias. The sense of the shift of the antiresonance frequency depends on the sign and the magnitude of the corresponding coefficients of the tensors of linear and nonlinear electrostriction. The theoretical predictions corroborate the experimental observations very well.
Two-dimensional freestanding membranes of materials, which can be transferred onto and make interfaces with any material, have attracted attention in the search for functional properties that can be utilized for next-generation nanoscale devices. We fabricated stable 1-nm-thick hafnia membranes exhibiting the metastable rhombohedral structure and out-of-plane ferroelectric polarizations as large as 13 μC/cm2. We also found that the rhombohedral phase transforms into another metastable orthorhombic phase without the ferroelectricity deteriorating as the thickness increases. Our results reveal the key role of the rhombohedral phase in the scale-free ferroelectricity in hafnia and also provide critical insights into the formation mechanism and phase stability of the metastable hafnia. Moreover, ultrathin hafnia membranes enable heterointerfaces and devices to be fabricated from structurally dissimilar materials beyond structural constrictions in conventional film-growth techniques.
18 February 2010 in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
A tunable membrane-type thin film bulk acoustic wave resonator (TFBAR) based on a Ba0.3Sr0.7TiO3 (BST) thin film has been fabricated. The resonance and antiresonance frequencies of the device can be altered by applying a dc bias: both shift down with increasing dc electric field. The resonance and antiresonance frequencies showed a tuning of -2.4% and -0.6%, respectively, at a maximum dc electric field of 615 kV/cm. The electromechanical coupling factor of the device increased up to 4.4%. We demonstrate that the tuning of the TFBAR is nonhysteretic. The Q-factor of the device showed some variation with dc bias and is about 200. The tuning of the TFBAR is caused by the dc bias dependence of the sound velocity and the intrinsic electromechanical coupling factor of the BST layer. We apply our recently developed theory on the electrical tuning of dc bias induced acoustic resonances in paraelectric thin films to successfully model the tuning behavior of the TFBAR. The modeling enabled us to de-embed the intrinsic electromechanical properties of the BST thin film. We show that the mechanical load of our device does not significantly degrade the tuning performance of the BST layer. The performance of the TFBAR is compared with the available data on varactor tuned TFBARs.
1 June 2011 in Science and Technology of Advanced Materials
We have studied the strain field around the 90° domains and misfit dislocations in PbTiO3/SrTiO3 (001) epitaxial thin films, at the nanoscale, using the geometric phase analysis (GPA) combined with high-resolution transmission electron microscopy (HRTEM) and high-angle annular dark field--scanning transmission electron microscopy (HAADF-STEM). The films typically contain a combination of a/c-mixed domains and misfit dislocations. The PbTiO3 layer was composed from the two types of the a-domain (90° domain): a typical a/c-mixed domain configuration where a-domains are 20-30 nm wide and nano sized domains with a width of about 3 nm. In the latter case, the nano sized a-domain does not contact the film/substrate interface; it remains far from the interface and stems from the misfit dislocation. Strain maps obtained from the GPA of HRTEM images show the elastic interaction between the a-domain and the dislocations. The normal strain field and lattice rotation match each other between them. Strain maps reveal that the a-domain nucleation takes place at the misfit dislocation. The lattice rotation around the misfit dislocation triggers the nucleation of the a-domain; the normal strains around the misfit dislocation relax the residual strain in a-domain; then, the a-domain growth takes place, accompanying the introduction of the additional dislocation perpendicular to the misfit dislocation and the dissociation of the dislocations into two pairs of partial dislocations with an APB, which is the bottom boundary of the a-domain. The novel mechanism of the nucleation and growth of 90° domain in PbTiO3/SrTiO3 epitaxial system has been proposed based on above the results.