1 February 2025 in APL Photonics
The Hanbury Brown–Twiss (HBT) effect holds a pivotal place in intensity interferometry and gave a seminal contribution to the development of quantum optics. To observe such an effect, both good spectral and timing resolutions are necessary. Most often, the HBT effect is observed for a single frequency at a time due to its limitations in dealing with multifrequencies simultaneously, halting and limiting some applications. Here, we report a fast and data-driven spectrometer built with a one-dimensional array of single-photon-sensitive avalanche diodes. We report observing the HBT effect for multiple frequencies at the same time. In particular, we observe the HBT effect for up to five lines of the Ne spectrum, but this can be improved upon to include more lines. Our work represents a major step in making spectral binning and multifrequency HBT more widely available. The technology we present can benefit both classical and quantum applications.
1 December 2024 in Journal of Instrumentation
Cross-talk is a well-known feature of single-photon avalanche detectors. It is especially important to account for this effect in applications involving temporal coincidences of two or more photons registered by the sensor since in this case the cross-talk may mimic the useful signal. In this work, we characterize the cross-talk of the LinoSPAD2 detector, as well as perform joint measurements of the cross-talk and Hanbury Brown-Twiss two-photon interference, comparing and cross-calibrating both effects. With a median dark count rate of 125 cps/pixel, we report the average cross-talk probability of 0.22% for the nearest neighbor and also observe a long-range cross-talk of the order 2 · 10-5% for channels separated by up to 20 pixels.
1 February 2026 in Journal of Instrumentation
We report the first characterization results of an optical time-stamping camera based on the Timepix4 chip coupled to a fully depleted optical silicon sensor and fast image intensifier, enabling sub-nanosecond scale, time-resolved imaging for single photons. The system achieves an RMS time resolution of 0.3 ns in direct detection mode without the intensifier and from 0.6 to 1.5 ns in the single-photon regime with an intensifier for different amplitude-based signal selections. This shows that Timepix4 provides a significant improvement over previous Timepix3-based cameras in terms of timing precision, and also in pixel count and data throughput. We analyze key factors that affect performance, including sensor bias and timewalk effect, and demonstrate effective correction methods to recover high temporal accuracy. The camera's temporal resolution, event-driven readout and high rate capability make it a scalable platform for a wide range of applications, including quantum optics, ultrafast imaging, and time-correlated photon counting experiments.
1 November 2024 in Review of Scientific Instruments
Runaway electrons, accelerated in a tokamak discharge to high energies (tens of MeV), can cause serious damage to plasma facing components. Therefore, it is important to develop effective mitigation strategies to reduce the risk of tokamak damage. To study the effects of various mitigation strategies, a dedicated diagnostic, the calorimetry probe, was developed at the COMPASS tokamak. This probe successfully measured the heat loads caused by runaway electrons directly, using a set of temperature sensors embedded in a graphite body. Deposited energy measured by the probe ranged from a few hundred joules up to (15 ± 1) kJ, while the mean deposited energy was (4.5 ± 1.1) kJ. The design of the probe and the initial results from 250 discharges covering four experimental campaigns dedicated to runaway electron studies (2019–2021) are presented in this article.