9 June 2015 in Physical Review Letters
Electronic structure of the three-dimensional colossal magnetoresistive perovskite has been established using soft-x-ray angle-resolved photoemission spectroscopy with its intrinsically sharp definition of three-dimensional electron momentum. The experimental results show much weaker polaronic coupling compared to the bilayer manganites and are consistent with the theoretical band structure including the empirical Hubbard parameter U. The experimental Fermi surface unveils the canonical topology of alternating three-dimensional electron spheres and hole cubes, with their shadow contours manifesting the rhombohedral lattice distortion. This picture has been confirmed by one-step photoemission calculations including displacement of the apical oxygen atoms. The rhombohedral distortion is neutral to the Jahn-Teller effect and thus polaronic coupling, but affects the double-exchange electron hopping and thus the colossal magnetoresistance effect.
4 February 2022 in Electronic Structure
Electronic structure of LaAlO3/SrTiO3 (LAO/STO) samples, grown at low oxygen pressure and post-annealed ex situ, was investigated by soft-x-ray ARPES focussing on the Fermi momentum (k F) of the mobile electron system (MES). X-ray irradiation of these samples at temperatures below 100 K creates oxygen vacancies (VOs) injecting Ti t 2g-electrons into the MES. At this temperature the oxygen out-diffusion is suppressed, and the VOs should appear mostly in the top STO layer. The x-ray generated MES demonstrates, however, a pronounced three-dimensional (3D) behavior as evidenced by variations of its experimental k F over different Brillouin zones. Identical to bare STO, this behavior indicates an unexpectedly large extension of the x-ray generated MES into the STO depth. The intrinsic MES in the standard LAO/STO samples annealed in situ, in contrast, demonstrates purely two-dimensional (2D) behaviour. The relevance of our ARPES data analysis is supported by model calculations to compare the intensity vs gradient methods of the k F determination as a function of the energy resolution ratio to the bandwidth. Based on self-interaction-corrected DFT calculations of the MES induced by VOs at the interface and in STO bulk, we discuss possible scenarios of the puzzling 3D-ity. It may involve either a dense ladder of quantum-well states formed in a long-range interfacial potential or, more likely, x-ray-induced bulk metallicity in STO accessed in the ARPES experiment through a short-range interfacial barrier. The mechanism of this metallicity may involve remnant VOs and photoconductivity-induced metallic states in the STO bulk, and even more exotic mechanisms such as x-ray induced formation of Frenkel pairs.
4 March 2022 in Physical Review Research
Band bending at semiconductor surfaces and interfaces is the key to applications ranging from classical transistors to topological quantum computing. A semiconductor particularly important for optical as well as microwave devices is GaN. What makes the material useful is not only its large bandgap but also that it can be heavily doped to become metallic. Here, we apply soft-x-ray angle-resolved photoelectron spectroscopy (ARPES) to metallic Si-doped GaN to explore the electron density and momentum-resolved band dispersions of the valence and conduction electrons varying through the surface band-bending region. We find an upward band bending, where the measured band occupation reduces toward the surface, as probed with low photon energies . The band occupation approaches the bulk value, matching Hall effect measurements, as the photon energy increases to , where the photoelectron mean free path exceeds the spatial extent of the band-bending region. Our quantitative analysis of the experimental data describes the potential variation in the band-bending region via self-consistent Poisson-Schrödinger equations. We put forward an insightful model to simulate the ARPES spectra from this region through summing up the contribution from all atomic layers, weighted by the photoelectron mean free path, under in-phase conditions achieved at particular values of the photoelectron out-of-plane momentum. The model adequately describes the peculiarities of the ARPES spectra caused by the surface band bending, including the photon-energy dependence of the apparent band occupation and Fermi-surface area, and allows accurate determination of the band-bending profile and values of the photoelectron mean free path. Finally, comparison of our data with supercell density functional theory calculations reveals the preferential location of Si atoms as substitutional for Ga, with the doped electrons entering the GaN conduction bands without formation of separate impurity states as would occur for Si interstitials. Our theoretical and experimental results resolve fundamental questions underpinning device performance of the GaN-based and other semiconductor materials in general and demonstrate a general methodology for quantitative studies of electron states in the band-bending region.
30 August 2022 in Physical Review Materials
interface is among the most studied heterostructure materials due to the use of in the mainstream Si microelectronic technology. Following the discovery of new functionalities in such as ferroelectric and reversible resistance-switching properties, we study ultrathin films grown on highly doped ( and ) Si by means of synchrotron-based soft-x-ray spectroscopy techniques, such as x-ray photoelectron spectrosopy (XPS) and angle resolved photoelectron spectroscopy (ARPES). With angular resolution, we directly obtain the electronic dispersions (k) of the single-crystalline Si substrate in contact with the overlayer, depending on the Si doping and heat treatment, and determine the k-resolved band offset at the interface. Analysis of the Hf and Si core-level energies and line shapes as a function of photon energy yields band bending in and Si. The evolution of the Hf linewidth upon annealing points to development of a potential distribution across due to charged defects at the surface and interface with Si. The effect of intense x-ray beam on the interfaces, distorting their pristine electronic structure, is evaluated from the time evolution of line shape and position under irradiation. We propose a model explaining the effects of both heat treatment and x-ray irradiation on the electronic structure in terms of oxygen vacancies generated at the surface of and its interface to Si, where the released O atoms react with Si to form at the interface. The knowledge of the irradiation-dependent band bending is essential for precise determination of the k-dependent band offset locally at the interface.
25 February 2026 in Physical Review Applied