25 September 2015 in Journal of Materials Science
1 February 2016 in Journal of Dynamic Behavior of Materials
Particulate composites are widely used in the materials world. An understanding of their damage behaviour under a variety of loading conditions is necessary to inform models of their response to external stimuli. In the present experimental study, fine and coarse grained RDX-HTPB composites have been used to investigate the effect of loading rate on the degree of damage produced in polymer bonded explosives subjected to varying degrees of uniaxial compression. High strain rate loading (4 × 103 s−1) was achieved using a direct impact Hopkinson pressure bar and low strain rate loading (1 × 10−2 s−1) using an Instron mechanical testing machine. The causal metrics are the degree to which the samples were strained and the mechanical energy expended in straining them. The damage metric is the residual low rate compressive modulus of the samples. The quantitative, physically based, results discussed in terms of the Porter-Gould activated debonding damage model clearly demonstrate that for both fine and coarse fills there is a marked reduction in residual moduli as a function of imposed strain, and substantially less specific energy is required to cause the same level of damage at the lower strain-rate. In the case of the coarse grained composite there is some evidence for a change in damage mechanism at the higher strain-rate. We obtain a value for the measured work of adhesion and a measure of the effective modulus local to the damage site, as damage is actually occurring. The observed underlying behaviour should be broadly applicable to particulate composites, whenever stiff filler particles are held in a viscoelastic matrix.
14 December 2010 in Experimental Mechanics
1 January 2012 in AIP Conference Proceedings
Dynamic behavior of particulate/porous energetic materials in a broad range of dynamic conditions (low velocity impact and explosively driven expansion of rings) is discussed. Samples of these materials were fabricated using Cold Isostatic Pressing and Hot Isostatic Pressing with and without vacuum encapsulation. The current interest in these materials is due to the combination of their high strength and output of energy under critical conditions of mechanical deformation. They may exhibit high compressive and tensile strength with the ability to undergo bulk distributed fracture resulting in small size reactive fragments. The mechanical properties of these materials and the fragment sizes produced by fracturing are highly sensitive to mesostructure. For example, the dynamic strength of Al-W composites with fine W particles is significantly larger than the strength of composites with coarse W particles at the same porosity. The morphology of W inclusions had a strong effect on the dynamic strength and fracture pattern. Experimental results are compared with numerical data.
1 January 2012 in AIP Conference Proceedings
Understanding the behaviour of porous geological materials is important for developing models of the response of rock to explosive loading for mining applications. In this paper the structure and mineralogy of a sample of Gosford Sandstone were investigated. The components of the rock were modelled using density functional theory which predicts the variation in internal energy of the lattice with compression. From this the thermal properties of the rock were derived. The thermal expansion was measured experimentally using a laser interferometer and compared against these predictions.
14 December 2023 in Journal of Dynamic Behavior of Materials
We have used a split Hopkinson pressure bar arrangement to investigate impact-induced reaction of the secondary explosives HMX, RDX and PETN in granular form. Sentencing of the experiments was performed by detecting reaction light emission, the spectral analysis of which can also provide information about the temperature of reaction. We measure the fraction of the mechanical energy that passes through the specimens that is absorbed in the run up to reaction, which we refer to as the efficiency factor, and for these experiments is of order 5–10%. We postulate that the efficiency factor is a function of the microstructure. The measured amounts of energy that were absorbed are comparable to those amounts required to bulk heat the samples to their melt points. A critical absorbed energy for reaction implies a minimum duration of loading for a given mechanical power and efficiency factor, and this idea is supported by the observation that the more intense the loading, the shorter the time to reaction. Additionally, we postulate a critical minimum mechanical power below which heat is redistributed faster than it can be accumulated. A minimum mechanical power threshold in turn dictates a minimum pressure threshold; but the idea of a stand-alone critical pressure is not experimentally supported.