Andrew J. Luhmann

Andrew J. Luhmann

Auto-generated profile, based on publicly available information

Andrew J. Luhmann

Earth and Environmental Science, Wheaton College, Wheaton, USA

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 March 2017 in Water Resources Research
Verified
Journal Article
Open access
PDF file
ALAndrew J. Luhmann
Andrew J. Luhmann
BTBenjamin Tutolo
Benjamin Tutolo
BBBrian C. Bagley
Brian C. Bagley
DMDavid F. R. Mildner
David F. R. Mildner
WSWilliam E. Seyfried
William E. Seyfried
MSMartin O. Saar
Martin O. Saar
Four reactive flow‐through laboratory experiments (two each at 0.1 mL/min and 0.01 mL/min flow rates) at 150°C and 150 bar (15 MPa) are conducted on intact basalt cores to assess changes in porosity, permeability, and surface area caused by CO2‐rich fluid‐rock interaction. Permeability decreases slightly during the lower flow rate experiments and increases during the higher flow rate experiments. At the higher flow rate, core permeability increases by more than one order of magnitude in one experiment and less than a factor of two in the other due to differences in preexisting flow path structure. X‐ray computed tomography (XRCT) scans of pre‐ and post‐experiment cores identify both mineral dissolution and secondary mineralization, with a net decrease in XRCT porosity of ∼0.7%–0.8% for the larger pores in all four cores. (Ultra) small‐angle neutron scattering ((U)SANS) data sets indicate an increase in both (U)SANS porosity and specific surface area (SSA) over the ∼1 nm to 10 µm scale range in post‐experiment basalt samples, with differences due to flow rate and reaction time. Net porosity increases from summing porosity changes from XRCT and (U)SANS analyses are consistent with core mass decreases. (U)SANS data suggest an overall preservation of the pore structure with no change in mineral surface roughness from reaction, and the pore structure is unique in comparison to previously published basalt analyses. Together, these data sets illustrate changes in physical parameters that arise due to fluid‐basalt interaction in relatively low pH environments with elevated CO2 concentration, with significant implications for flow, transport, and reaction through geologic formations.

1 March 2017 in Chemical Geology
Verified
Journal Article
Closed access
ALAndrew J. Luhmann
Andrew J. Luhmann
BTBenjamin Tutolo
Benjamin Tutolo
CTChunyang Tan
Chunyang Tan
BMBruce M. Moskowitz
Bruce M. Moskowitz
MSMartin O. Saar
Martin O. Saar
WSWilliam E. Seyfried
William E. Seyfried

5 March 2020 in Journal of Geophysical Research: Solid Earth
Verified
Journal Article
Open access
PDF file
ZWZhidi Wu
Zhidi Wu
ALA. J. Luhmann
A. J. Luhmann
ARA. J. Rinehart
A. J. Rinehart
PMP. S. Mozley
P. S. Mozley
TDThomas Dewers
Thomas Dewers
BMB. S. Majumdar
B. S. Majumdar
Carbon capture, utilization, and storage may lead to mechanical degradation of the subsurface reservoir from fluid‐rock interaction, which could lead to wellbore instability or reservoir compaction. To better understand potential relationship between mechanical degradation with various carbonate cement textures and compositions in sandstone reservoirs, six flow‐through experiments were conducted. Formation water (TDS = 5,390 mg/L) enriched with CO2 flowed through two types of Pennsylvanian Morrow B Sandstone: an ankerite‐siderite‐cemented sandstone (disseminated cement texture) and a calcite‐cemented sandstone (poikilotopic cement texture). The experiments produced little change in permeability in the ankerite‐siderite‐cemented sandstone, but permeability increased up to more than 1 order of magnitude in the calcite‐cemented sandstone. Ultrasonic measurements and cylinder‐splitting tests (also known as Brazilian tests) suggested negligible mechanical degradation of the ankerite‐siderite‐cemented sandstone. Variable changes, with significant mechanical degradation in the static moduli, were observed in the calcite‐cemented sandstone. Thus, dissolution of the disseminated ankerite‐siderite cement (0.28–0.30%) had minimal impact on modifying the flow network and the mechanical integrity of the sandstone, whereas dissolution of the poikilotopic calcite cement (0.89–1.13%, quantified with fluid chemistry and visualized with X‐ray microcomputed tomography) impacted the mechanical strength of the sandstone by disconnecting framework grains. With the high water‐to‐rock mass ratios (7.3–8.2) and number of pore volumes (147–675) employed in these experiments, potential risks are most relevant to regions near injection wells. Ultimately, the chemo‐mechanical effects induced by CO2 injection are strongly influenced by the cement texture and composition and the burial history of the reservoir rock.

17 July 2023 in Applied Geochemistry
Verified
Journal Article
Closed access
JSJason Dylan Simmons
Jason Dylan Simmons
SWSai Wang
Sai Wang
ALAndrew J. Luhmann
Andrew J. Luhmann
ARAlex J. Rinehart
Alex J. Rinehart
JHJason E. Heath
Jason E. Heath
BMBhaskar S. Majumdar
Bhaskar S. Majumdar

13 September 2023 in International Journal of Greenhouse Gas Control
Verified
Journal Article
Closed access
SOSamuel Otu
Samuel Otu
ARAlex J. Rinehart
Alex J. Rinehart
ALAndrew J. Luhmann
Andrew J. Luhmann
JSJason Dylan Simmons
Jason Dylan Simmons
PMPeter Mozley
Peter Mozley

12 April 2023 in Journal of Geophysical Research: Solid Earth
Verified
Journal Article
Closed access
SBS. L. Bilek
S. L. Bilek
ALA. J. Luhmann
A. J. Luhmann
RGR. Grapenthin
R. Grapenthin
HWHan Byul Woo
Han Byul Woo
JGJ. A. Gochenour
J. A. Gochenour