11 January 2016 in Journal of Geophysical Research: Solid Earth
We present a new 3‐D S wave velocity model of the northeast (NE) China from the joint inversion of the Rayleigh wave ellipticity and phase velocity at 8–40 s periods. Rayleigh wave ellipticity, or Rayleigh wave Z/H (vertical to horizontal) amplitude ratio, is extracted from both earthquake (10–40 s) and ambient noise data (8–25 s) recorded by the NorthEast China Extended SeiSmic Array with 127 stations. The estimated Z/H ratios from earthquake and ambient noise data show good consistency within the overlapped periods. The observed Z/H ratio shows a good spatial correlation with surface geology and is systematically low within the basins. We jointly invert the measured Z/H ratio and phase velocity dispersion data to obtain a refined 3‐D S wave velocity model beneath the NE China. At shallow depth, the 3‐D model is featured by strong low‐velocity anomalies that are spatially well correlated with the Songliao, Sanjiang, and Erlian basins. The low‐velocity anomaly beneath the Songliao basin extends to ~ 2–3 km deep in the south and ~5–6 km in the north. At lower crustal depths, we find a significant low‐velocity anomaly beneath the Great Xing'an range that extends to the upper mantle in the south. Overall, the deep structures of the 3‐D model are consistent with previous models, but the shallow structures show a much better spatial correlation with tectonic terranes. The difference in sedimentary structure between the southern and northern Songliao basin is likely caused by a mantle upwelling associated with the Pacific subduction.
14 October 2017 in Geophysical Journal International
The time–frequency domain phase-weighted stacking (tf-PWS) technique based on the S transform has been employed in stacking empirical Green's functions (EGFs) derived from ambient noise data, mainly due to its superior power in enhancing weak signals. Questions such as the induced waveform distortion and the feasibility of phase-velocity extraction are yet to be thoroughly explored. In this study, we investigate these issues by conducting extensive numerical tests with both synthetic data and USArray transportable array (TA) ambient noise data. We find that the errors in the measured phase velocities associated with waveform distortion caused by the tf-PWS depend largely on the way of how the inverse S transform (IST) is implemented. If frequency IST is employed in tf-PWS, the corresponding errors are generally less than 0.1 per cent, sufficiently small that the measured phase velocities can be safely used in regular surface wave tomography. On the other hand, if a time IST is used in tf-PWS, then the extracted phase velocities are systematically larger than those measured from linearly stacked ones, and the discrepancy can reach as much as ∼0.4 per cent at some periods. Therefore, if tf-PWS is used in stacking EGFs, then frequency IST is preferred to transform the stacked S spectra back to the time domain for the stacked EGFs.
9 March 2021 in Geochemistry, Geophysics, Geosystems
In this study, we built a high‐resolution 3D S‐wave velocity model of the South China Sea (SCS) and adjacent areas by the joint inversion of surface wave dispersions retrieved from ambient noise and earthquake data. We first measured Rayleigh wave phase velocity dispersions from the waveforms recorded by 94 broadband seismic stations. Subsequently, we used a generalized least squares inversion scheme with spatially varying resolution to perform 2D tomographic inversion at different periods. Lastly, we performed 1D inversion at different grid points and obtained the 3D S‐wave velocity model in the depth range of 15–250 km. Our model reveals a prominent high velocity (high‐V) anomaly beneath the SCS basin and shows that the lithosphere beneath the SCS basin is about 70–80 km thick. We observe a prominent low velocity (low‐V) anomaly in the asthenosphere beneath the SCS basin, and we interpret this as evidence for the ongoing partial melting of the asthenosphere. An obvious high‐V anomaly is also revealed beneath the Khorat Plateau (KP) in the depth range of 80–150 km, suggesting that the KP has a cold and thick lithosphere and has suffered limited destruction in the Cenozoic era. In the northern part of Kalimantan Island (KI), a prominent low‐V anomaly is shown in the upper 60 km of the lithosphere revealing the upwelling of the asthenosphere. Our findings shed lights on the tectonic evolution of the SCS and adjacent areas.
5 December 2016 in Geophysical Journal International
In this study, we demonstrate the feasibility of imaging broad-band (10–150 s) Rayleigh wave phase velocity maps on a continental scale using ambient noise tomography (ANT). We obtain broad-band Rayleigh waves from cross-correlations of ambient noise data between all station pairs of USArray and measure the dispersion curves from these cross-correlations at a period band of 10–150 s. The large-scale dense USArray enables us to obtain over 500 000 surface wave paths which cover the contiguous United States densely. Using these paths, we generate Rayleigh wave phase velocity maps at 10–150 s periods. Our phase velocity maps are similar to other reported phase velocity maps based on ambient noise data at short periods (<50 s) and based on earthquake data at intermediate/long periods (50–90 s). This study extends ANT from short/intermediate periods (<50 s) to long periods up to 150 s in a continental scale of the USA. These broad-band phase velocity maps from ANT can be used to construct 3-D lithospheric and asthenospheric velocity structures.
8 December 2020 in Geophysical Journal International
SUMMARY: Determining a detailed 3-D velocity model with high resolution for the sedimentary layer in the Sichuan Basin is potentially beneficial both to the industrial oil/gas exploration and earthquake hazards’ mitigation. In this study, we apply the ambient noise tomography method to construct a 3-D S-wave velocity model. This model focuses on the sedimentary layer of the Sichuan Basin, with a 0.3° × 0.3° grid precision. Dispersion curves of both group and phase velocities of Rayleigh wave at 4 to 40 s periods are utilized, which are extracted from 87 broad-band stations in the Sichuan Basin and the surrounding areas. The 3-D model reveals a thick sedimentary layer of the Sichuan Basin with S-wave velocity ranging from ∼2.0 to 3.4 km s−1. The sediment thickness in the margins of the Sichuan Basin is generally greater than the typical values of 6–10 km in the central areas due to surrounding orogenic activities, with a maximum depth of ∼13 km in the northwestern margin. Moreover, a prominent low S-wave velocity anomaly in the margins may be caused by the sediment accumulations from large-scale landslides and pronounced denudation of the surrounding orogenic belts. Major geologic units in the sedimentary layer are delineated in this study. The S-wave velocity values within each geologic unit and their bottom interfaces are obtained. Based on our model, we calculate synthetic ground motions for the 2013 Lushan earthquake and obtain the distribution of the peak ground acceleration from the earthquake epicentre to the western Sichuan Basin. The result clearly illustrates the basin amplification effect on the seismic waves.
7 September 2024 in Earth and Space Science
In the nearshore area, ocean current display intricate complexities due to interactions among tide, river, and coastline, which makes accurate current modeling challenging. Continuous in situ observation with high spatial and temporal resolution helps to better understand the dynamics of these currents. In this study, we used a 10‐km long submarine fiber‐optic cable with distributed acoustic sensing technology to record seismic signals associated with ocean waves. The current velocity and water depth were obtained from the velocity dispersion using frequency‐wave number analysis matched against theoretical ocean wave propagation equations. The results show remarkable agreement with observation of a nearby current meter, confirming the dominance of tidal currents as well as a small‐scale residual current. The temporal variation of water depth is consistent with observation by a nearby tidal gauge. This study demonstrates the potential of using submarine fiber‐optic cable for long‐term, high‐resolution, near real‐time nearshore current monitoring.