Roman A. Maslenkin

Roman A. Maslenkin

Auto-generated profile, based on publicly available information

Roman A. Maslenkin


Research Focus & Metrics

Academic Career Length

1Year (2026-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 May 2026 in Petroleum Chemistry
Verified
Journal Article
Closed access
RMRoman A. Maslenkin
Roman A. Maslenkin
ISIrina Shamanaeva
Irina Shamanaeva
EVEkaterina E. Vorob’EVa
Ekaterina E. Vorob’EVa
C Anastasia Chemes
Anastasia Chemes
AVAndrei V. Volik
Andrei V. Volik
EPEkaterina V. Parkhomchuk
Ekaterina V. Parkhomchuk

1 October 2026 in Petroleum Chemistry
Verified
Journal Article
Closed access
PDF file
VVVsevolod A. Vdovichenko
Vsevolod A. Vdovichenko
RMRoman A. Maslenkin
Roman A. Maslenkin
KBKsenia A. Babina
Ksenia A. Babina
EVEkaterina E. Vorobyeva
Ekaterina E. Vorobyeva
ASAlexander V. Shnayder
Alexander V. Shnayder
EPEkaterina V. Parkhomchuk
Ekaterina V. Parkhomchuk
A composite 7.5% Ni/(50% HZSM-5 + 50% γ,η-Al2O3) catalyst was synthesized for hydroisodewaxing of the kerosene–diesel fraction of pyrolysis oil obtained from polyethylene and polypropylene waste. Medium-pore ZSM-5 zeolite (Si/Al = 40), prepared by the hydrothermal method, was used as the acid component. The catalyst was tested in hydroprocessing of the pyrolysis oil fraction at T = 320, 340, and 360°C, P(H2) = 40 bar, LHSV = 1 h–1, and H2/feed = 1000 L (20°C, 1 atm)/L (20°C). With Ni as the active component, alkenes and dienes were almost completely hydrogenated to a residual content of no more than 1–2%, whereas dewaxing of the feedstock proceeded on the acid sites of ZSM-5 zeolite through isomerization and selective cracking of n-alkanes owing to the molecular-sieve selectivity toward unbranched molecules. With increasing temperature, the iso-/n-alkane ratio rose from 0.3 in the feedstock to 0.7 at 320°C and to 1.5–1.6 at 340–360°C, while the n-paraffin content in the kerosene–diesel fraction decreased to 1–2% in the C9+ range and high-boiling C15–C16 n-paraffins were completely removed. More extensive dewaxing with increasing temperature was accompanied by lower selectivity to iso-alkanes because of enhanced cracking of n-alkanes with gas formation, accumulation of cyclic and aromatic compounds, and catalyst coking. The optimal balance between the extent of hydroisodewaxing and the yield of middle distillates was achieved at 320°C, which provides a cloud point of −10°C; this demonstrates the potential of the developed catalyst for hydroprocessing pyrolysis oil into motor-fuel components with improved low-temperature properties.