Dawei Liu

Dawei Liu

Auto-generated profile, based on publicly available information

Dawei Liu

Faculty of Engineering, University of Bristol, UK

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 March 2017 in IEEE Transactions on Power Electronics
Verified
Journal Article
Open access
HDHarry C. P. Dymond
Harry C. P. Dymond
JWJianjing Wang
Jianjing Wang
DLDawei Liu
Dawei Liu
JDJeremy J. O. Dalton
Jeremy J. O. Dalton
NMNeville McNeill
Neville McNeill
BSBernard H. Stark
Bernard H. Stark
Active gate driving has been demonstrated to beneficially shape switching waveforms in Si- and SiC-based power converters. For faster GaN power devices with sub-10-ns switching transients, however, reported variable gate driving has so far been limited to altering a single drive parameter once per switching event, either during or outside of the transient. This paper demonstrates a gate driver with a timing resolution and range of output resistance levels that surpass those of existing gate drivers or arbitrary waveform generators. It is shown to permit active gate driving with a bandwidth that is high enough to shape a GaN switching during the transient. The programmable gate driver has integrated high-speed memory, control logic, and multiple parallel output stages. During switching transients, the gate driver can activate a near-arbitrary sequence of pull-up or pull-down output resistances between 0.12 and 64 Ω. A hybrid of clocked and asynchronous control logic with 150-ps delay elements achieves an effective resistance update rate of 6.7 GHz during switching events. This active gate driver is evaluated in a 1-MHz bridge-leg converter using EPC2015 GaN FETs. The results show that aggressive manipulation of the gate-drive resistance at sub-nanosecond resolutions can profile gate waveforms of the GaN FET, thereby beneficially shaping the switch-node voltage waveform in the power circuit. Examples of open-loop active gate driving are demonstrated that maintain the low switching loss of constant-strength gate driving, while reducing overshoot, oscillation, and EMI-generating high-frequency spectral content.

18 February 2016 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
DLDawei Liu
Dawei Liu
SHSimon J. Hollis
Simon J. Hollis
HDHarry C. P. Dymond
Harry C. P. Dymond
NMNeville McNeill
Neville McNeill
BSBernard H. Stark
Bernard H. Stark
A new design method for producing high-performance and power-rail slew-tolerant floating-voltage level shifters is presented, offering increased speed, reduced power consumption, and smaller layout area compared with previous designs. The method uses an energy-saving pulse-triggered input, a high-bandwidth current mirror, and a simple full latch composed of two inverters. A number of optimizations are explored in detail, resulting in a presented design with a dV dd slew immunity of 30 V/ns, and near-zero static power dissipation in a 180-nm technology. Experimental results show a delay of below 370 ps for a level-shift range of 8-20 V. Postlayout simulation puts the energy consumption at 2.6 pJ/bit at 4 V and 7.2 pJ/bit at 20 V, with near symmetric rise and fall delays.

1 October 2017
Verified
Conference Paper
Closed access
HDHarry C. P. Dymond
Harry C. P. Dymond
DLDawei Liu
Dawei Liu
JWJianjing Wang
Jianjing Wang
JDJeremy J. O. Dalton
Jeremy J. O. Dalton
BSBernard H. Stark
Bernard H. Stark
Active gate driving has been shown to provide reduced circuit losses and improved switching waveform quality in power electronic circuits. An integrated active gate driver with 150 ps resolution has previously been shown to offer the expected benefits in GaN-based converters. However, the use of low-voltage, high-speed transistors limits its output voltage range to 5 V, too low for many emerging SiC and GaN devices. This paper introduces a series connection of two commercially available conventional drivers and an improved 5 V, 100 ps resolution active driver. The first conventional driver lifts the gate voltage from the negative hold-off voltage to just below the gate threshold voltage, the active driver performs active high-resolution control around the gate threshold, after which the second conventional driver raises the gate voltage to reach optimal Rdson values. This driver is demonstrated on a 900-V SiC MOSFET that requires a 15 V onstate gate voltage to achieve optimum Rdson. The device is switched at 50 V/ns in a 100-kHz, non-synchronous, 1:10, 300-W boost converter, with the power device switching 600 V and 5 A. It is shown that the gate voltage can be affected on a 100 ps scale, and that meaningful changes to fast power waveforms can be achieved.

14 November 2018 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Open access
DLDawei Liu
Dawei Liu
SHSimon J. Hollis
Simon J. Hollis
BSBernard H. Stark
Bernard H. Stark
Dual-output gate drivers for switched-mode power supplies require low-side reference signals to be shifted to the switch-node potential. With the move to ultra-fast switching GaN converters, there is a commercial need to achieve switch-node slew-rates exceeding 100 V/ns, however, reported level shifters do not simultaneously achieve the required power supply slew immunities and sub-ns propagation delays. This paper presents a novel design technique to achieve the first floating voltage level shifters that deliver slew-rate immunities above 100 V/ns and sub-ns delay in the same circuit. Step-by-step transistor-level design methods are presented. This technique is applied to improve a reported level shifter, and experimentally validated by fabricating this level shifter in a 180 nm high-voltage CMOS process. The final level shifter has zero static power consumption, and is shown to have a sub-nanosecond delay across the whole operating range, a 200 V/ns positive power-rail slew tolerance, and infinite negative slew tolerance. The measured propagation delay decreases from 722 ps with the floating ground at -1.5 V, to 532 ps for a floating ground of 45 V, and the power consumption is 30.3 pJ per transition at 45 V. It has a figure of merit of 0.06 ns/(μmV), which is an 1.7x improvement on the next best reported level shifter for this type of application.

1 September 2018
Verified
Conference Paper
Closed access
JWJianjing Wang
Jianjing Wang
MHMohammad H. Hedayati
Mohammad H. Hedayati
DLDawei Liu
Dawei Liu
SASalah-Eddine Adami
Salah-Eddine Adami
HDHarry C. P. Dymond
Harry C. P. Dymond
BSBernard H. Stark
Bernard H. Stark
Di/dt has previously been proposed as a temperature indicator for Si and SiC devices, however, the evaluation of its viability for GaN devices is challenging as known current sensors introduce significant unwanted parasitic inductance. This work presents a figure-of-eight magnetic field sensor ( ∞-sensor) that permits, for the first time, high-bandwidth floating current sensing, with negligible insertion impedance and influence on switching performance, in highspeed GaN and SiC switching circuits. The pair of coils are connected in a way that the measurement is immune to currents outside of the sensing region. The simulated bandwidth of the sensor, taking into account the loading by the probe connected to its output, is 225 MHz. The insertion inductance is 0.2 nH, and the insertion resistance is 4.2 mΩ at 100 MHz. This sensor is used to investigate the temperature dependency of turn-on Di/dt in a 650 V, 52 mΩ GaN device. It is found that both average and peak turn-on Di/dt decrease with temperature. Peak Di/dt appears to be the preferred temperature indicator due to its high sensitivity and linearity.

14 December 2020 in IEEE Transactions on Power Electronics
Verified
Journal Article
Open access
DLDawei Liu
Dawei Liu
HDHarry C. P. Dymond
Harry C. P. Dymond
SHSimon J. Hollis
Simon J. Hollis
JWJianjing Wang
Jianjing Wang
Neville McNeillNeville McNeill
Neville McNeill
BSBernard H. Stark
Bernard H. Stark
Active gate driving of power devices seeks to shape switching trajectories via the gate, for example to reduce EMI without degrading efficiency. To this end, driver ICs with integrated arbitrary waveform generators have been used to achieve complex gate signals. In this paper, we describe for the first time the implementation details of a digitally programmable arbitrary waveform gate driver capable of a 10 GHz waypoint rate, including comprehensive design considerations for critical high-speed subsystems that codify the trade-off in flexibility, speed and area. Our design, which is taped out in a 180 nm high-voltage CMOS process, utilises buffers that switch up to ten times in a single clock cycle to overcome the limited achievable clock-speed of high-voltage silicon integrated circuits, and a fully digital architecture to provide robustness under high slew-rates of the ground rail. The driver IC has networks of 100 ps delay elements that are digitally configured prior to a switching transient, to selectively control an array of fast, parallel-connected drivers with different output impedances. Key to the high timing resolution are high-speed asynchronous circuits for memory readout, output buffering and pulse generation. The driver IC is experimentally evaluated to have a 100 ps resolution, and to operate reliably in a 400 V GaN bridge leg, under ground-rail voltage slew rates peaking at over 100 V/ns. Design rules are provided to obtain an architecture with the least area for a given set of timing and impedance resolution requirements. The reported design methods enable complex driving waveforms to be applied during nanosecond-scale transients of GaN power devices and demonstrate how digitally-programmable active gate drivers for GaN power FETs can be designed to meet a given set of application requirements.