Min Wang

Min Wang

Auto-generated profile, based on publicly available information

Min Wang

Technology Training Center, State Grid Henan Electric Power Company, Zhengzhou, Henan, China

Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
2 September 2025 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
SYShuai Yuan
Shuai Yuan
MWMin Wang
Min Wang
ZZZheng Zhou
Zheng Zhou
CLChen Liang
Chen Liang
XWXiyan Wang
Xiyan Wang
ZLZhenghui Li
Zhenghui Li
The calculation of the dynamic temperature distribution of on-board traction transformers in high-speed electric multiple unit (EMU) is a key step in the verification of the rationality of the design, the assessment of insulation status, and other thermal related work. However, for dry-type on-board traction transformers (D-OBTTs) that are rapidly developing in the context of on-board equipment lightweight, due to their special cooling mode, existing dynamic thermal modeling methods cannot be directly applied. In this article, a dynamic temperature distribution calculation method applicable to D-OBTT is proposed. First, a dynamic thermal network modeling method for the winding area is presented. Then, a convection heat transfer intensity model applicable to the air duct area was obtained based on the dimensional analysis theory. Furthermore, a lumped parameter thermal-circuit model was constructed to obtain the necessary reference temperature in the dynamic thermal network model. Finally, a thermal test under dynamic traction load was conducted on the experimental setup to validate the proposed model. The experimental results indicate that the model proposed in this article has sufficient accuracy and computational efficiency, thus providing an efficient and reliable dynamic temperature distribution calculation method for the optimal design and lifespan evaluation of D-OBTT.

12 May 2026 in IEEE Transactions on Dielectrics and Electrical Insulation
Verified
Journal Article
Closed access
SYShuai Yuan
Shuai Yuan
MCMengru Chen
Mengru Chen
ZZZheng Zhou
Zheng Zhou
CLChen Liang
Chen Liang
MWMin Wang
Min Wang
LZLijun Zhou
Lijun Zhou
The lightweight dry-type on-board traction transformer (D-OBTT) is a key technology for enabling higher operating speeds in electric multiple units. Achieving this goal critically depends on improving the thermal conductivity of the cast insulation material for the windings. Although silicone rubber (SR) offers excellent electrical insulation, its inherently low thermal conductivity limits further weight reduction in D-OBTTs. While hexagonal boron nitride (h-BN) possesses high intrinsic thermal conductivity, relying solely on this single filler to enhance thermal performance requires high loading levels, which leads to significant deterioration in the mechanical properties of the composite and greatly increases processing difficulty, hindering practical engineering application. In this work, h-BN/carbon fiber (CF)/SR composites were prepared by utilizing the synergistic effect between h-BN and CF. Under a total filler loading of 40 phr, the partial replacement of h-BN with 8 phr CF raised the thermal conductivity to 0.6239 W·m-1·K-1, yielded a tensile strength of 8.23 MPa and an elongation at break of 1926.15%, while meeting the insulation requirements specified in the relevant standards. Compared to the h-BN/SR composite, these values represent improvements of 50.22% in thermal conductivity, 18.93% in tensile strength, and 13.88% in elongation at break, confirming the effectiveness of the synergistic effect. This work establishes a material foundation for the insulation system in next-generation D-OBTTs.