Development of molecular beam epitaxy (MBE) of two-dimensional (2D) layered materials is an inevitable step in realizing novel devices based on 2D materials and heterostructures. However, due to existence of numerous polytypes and occurrence of additional phases, the synthesis of 2D films remains a difficult task. This paper reports on MBE growth of GaSe, InSe, and GaTe layers and related heterostructures on GaAs(001) substrates by using a Se valve cracking cell and group III metal effusion cells. The sophisticated self-consistent analysis of X-ray diffraction, transmission electron microscopy, and Raman spectroscopy data was used to establish the correlation between growth conditions, formed polytypes and additional phases, surface morphology and crystalline structure of the III–VI 2D layers. The photoluminescence and Raman spectra of the grown films are discussed in detail to confirm or correct the structural findings. The requirement of a high growth temperature for the fabrication of optically active 2D layers was confirmed for all materials. However, this also facilitated the strong diffusion of group III metals in III–VI and III–VI/II–VI heterostructures. In particular, the strong In diffusion into the underlying ZnSe layers was observed in ZnSe/InSe/ZnSe quantum well structures, and the Ga diffusion into the top InSe layer grown at ~450 °C was confirmed by the Raman data in the InSe/GaSe heterostructures. The results on fabrication of the GaSe/GaTe quantum well structures are presented as well, although the choice of optimum growth temperatures to make them optically active is still a challenge.
21 June 2016 in Journal of Physics D: Applied Physics
Photoluminescence (PL) properties of type-II InSb/InAs periodic nanostructures containing above-monolayer (ML)-thick InSb insertions, grown by molecular beam epitaxy, are studied by using an FTIR spectrometer in wide temperature range. The samples exhibit bright PL in the 3.5–5.5 μ m range, which is attributed to recombination of holes localized in InSb with electrons accumulated nearby in the InAs matrix. An increase in the InSb nominal thickness from 1 ML to 1.6 ML results in an increase of the PL peak wavelength up to 5.5 μ m (300 K), and significantly improves luminescence intensity at 300 K due to a twice larger energy of hole localization. The InSb/InAs nanostructures also demonstrate an anomalous ‘blue’ shift of the PL peak energy as the temperature increases in the 12–80 K range, which is attributed to the thermally induced population of localized states in the InSb insertions, emerging due to composition/thickness fluctuations. Sb segregation in the cap InAs barrier smooths the potential inhomogeneities in the insertions, which reduces the broadening parameter.
A method for measuring photoreflectance (PR) by using a Fourier transform infrared (FTIR) spectrometer has been implemented. Features of application of the phase-correction method necessary for...
1 February 2019 in Progress in Crystal Growth and Characterization of Materials
The effect of external electric field on interband optical transitions in single InxGa1 − xAs/GaAs quantum wells is studied by electroreflectance spectroscopy. A procedure is suggested for separating the contribution of particular exciton transitions to the complicated modulation spectrum. Nontrivial field dependences of the probability of optical transitions forbidden by the symmetry are observed experimentally. The data are compared with the corresponding theoretical dependences. The strength of the internal electric field in the region of the quantum well is determined from Frantz-Keldysh’s oscillations. Under certain electric fields, the probability of transitions forbidden with no field is higher than the probability of transitions allowed by the symmetry.